## Abstract A three‐stage low‐noise amplifier (LNA) fabricated in a standard 0.18‐μm CMOS process (__f__~__T__~ = 45 GHz) with a maximum gain of 18 dB at 23.2 GHz and a 5.8‐dB noise figure is presented. Parallel feedback between the gate and drain is used in all three stages. This configuration als
A 40-GHz Low-Noise Amplifier With a Positive-Feedback Network in 0.18- CMOS
✍ Scribed by Hsieh-Hung Hsieh; Liang-Hung Lu
- Book ID
- 114661143
- Publisher
- IEEE
- Year
- 2009
- Tongue
- English
- Weight
- 743 KB
- Volume
- 57
- Category
- Article
- ISSN
- 0018-9480
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
## Abstract A 20‐GHz CMOS low‐noise amplifier (LNA) fabricated with the 0.18 μm process is presented. This two‐stage cascaded common source LNA exhibits low power consumption with a satisfying performance such as overall gain and noise figure (NF). The measurement is performed on‐wafer. The 20‐GHz
## Abstract A three‐stage 30‐GHz low noise amplifier (LNA) was designed and fabricated in a standard 0.18‐μm CMOS technology. The LNA has demonstrated a 10‐dB gain and a minimum noise figure of 5.2 dB at 30 GHz. The achieved input 1‐dB compression point (IP~1 dB~) and third order intercept point (I
A 0.18-lm CMOS low-noise amplifier (LNA) operating over the entire ultrawideband (UWB) frequency range of 3.1-10.6 GHz, has been designed, fabricated, and tested. The UWB LNA achieves the measured power gain of 7.5 6 2.5 dB, minimum input matching of À8 dB, noise figure from 3.9 to 6.3 dB, and IIP3
## Abstract A 3–6 GHz broadband CMOS single‐ended LNA fabricated with the 0.18 μm 1P6M process for UWB and WLAN receiver is presented. Due to its noncascode circuit architecture, the proposed LNA can operate under 1V supply voltage and 6mA current consumption. In the UWB low band (3.1–5.15 GHz), th