## Abstract In this paper, a compact microstrip bandpass filter with wide stopband performance is presented. Wide stopband performance is achieved by introducing both stepped‐impedance resonator and over‐coupling technique. With the new structure, the filter has not only wide upper stopband perform
Design of stepped-impedance hairpins band-pass filter with wide stopband performance
✍ Scribed by Min-Hua Ho; Wei-Chen Lin
- Publisher
- John Wiley and Sons
- Year
- 2010
- Tongue
- English
- Weight
- 474 KB
- Volume
- 52
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
In this article, the band‐pass filter (BPF) of stepped‐impedance hairpin (SIH) design having a very wide stopband performance was proposed.The filter composed of two SIHs connected by a narrow bended microstrip with the latter's middle point shorting to the ground through a via hole. A long narrow coupled microstrip was used to couple I/O signal to/from the SIH resonators. The filter operated at a quarter‐wavelength resonance condition was built for WLAN IEEE 802.11b/g (2.4/2.45 GHz) applications. The filter's upper stopband had its frequency range measured from 2.76 to 23.08 GHz with the criterion of the signal rejection levels greater than 20 dB. The stopband's upper‐end is over 9.5 f~0~ (with central frequency, f~0~ = 2.44 GHz). Experiment was conducted for the circuit validation and a good agreement was observed between the measurement and simulation. © 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52: 1405–1408, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.25179
📜 SIMILAR VOLUMES
We present the development of a miniaturized broadband Wilkinson power divider on a multilayer organic substrate with integrated thin film resistors. The VSWR for all port for both dividers is better than 1.6:1, the excess insertion loss is less than 1.6 dB up to 18 GHz, and 12 dB of isolation is re
## Abstract We proposed a compact microstrip band‐pass filter with wide stopband in this article.Microstrip gap and interdigital capacitor combine with stub inductors shorted to the ground plane by via were used to take advantage of different aspects of left‐handed behavior to achieve compact size
## Abstract Stepped impedance hairpin resonators (SIHRs) with harmonic suppression and capability of frequency tuning are incorporated into a bandpass filter design. A tapped‐in U‐shaped feed structure is introduced to suppress harmonics and to reduce the passband insertion losses. The passband fle
## Abstract In this letter, a novel microstrip bandpass filter (BPF) with half asymmetric resonators is presented.With Filter structure and capacitively loaded coupling, a wide bandwidth with sufficient rejection level can be achieved easily. The electromagnetic simulation is used, and the prototyp
## Abstract In this article, we propose a dual‐mode bandpass filter (BPF) at 1.575 GHz using periodic meander slotted ground structures (M‐SGSs) which are etched on the ground plane for spurious suppression. First, single M‐SGS is analyzed. Second, the M‐SGSs are used to provide a good stopband‐rej