This paper presents a novel square-cylindrical monopole antenna fabricated using a single metal plate. A prototype of the proposed antenna with a cross-sectional area of 10 Ο« 10 mm 2 and a length of 30 mm is implemented, and the measured results indicate that the antenna can provide good omnidirecti
Wide-band omnidirectional square cylindrical metal-plate monopole antenna
β Scribed by Kin-Lu Wong, ; Chih-Hsien Wu,
- Book ID
- 121753748
- Publisher
- IEEE
- Year
- 2005
- Tongue
- English
- Weight
- 721 KB
- Volume
- 53
- Category
- Article
- ISSN
- 0018-926X
No coin nor oath required. For personal study only.
π SIMILAR VOLUMES
former applied as a /4 matching line between two different impedances, and is also without etching in the ground plane. Two typical examples are introduced: matching between 50β and 25β and between 50β and 12.5β. In both cases the reduction of the length of the proposed /4 line is 60% (or higher), c
## Abstract This article provides a study of monopoles derived from planar configurations by repeated plate rotation. A comparison of four prototypes shows that an increasing number of plates broadens the Hβplane 100% pattern uniformity bandwidth. At the same time, a very broad impedance bandwidth