## Abstract A rectangular patch resonator with four equal slits etched on sides is presented to make up a stopband‐improved dual‐mode filter. By stretching these four side slits towards the patch center, the first resonant frequency gets a gradual decrease while its second one keeps almost unchange
Stopband improvement of a dual-mode ring bandpass filter using DGS
✍ Scribed by Min Hung Weng; Hung Wei Wu
- Publisher
- John Wiley and Sons
- Year
- 2004
- Tongue
- English
- Weight
- 113 KB
- Volume
- 44
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
This paper presents the improved stopband of a novel dual‐mode bandpass filter (BPF) using an etched H‐shaped defected ground structure (DGS) at 2 GHz. The wide‐stopband characteristic results from the rejection‐band resonant characteristic of the DGS in the harmonic frequency of the dual‐mode BPF. The proposed BPF is designed and fabricated with the following frequency characteristics: central frequency f~0~ = 2 GHz, 3‐dB bandwidth of 3%, and wide stopband from 2.5 to 5 GHz at −40 dB. The measured results of the fabricated filter show good agreement with the simulation results. © 2005 Wiley Periodicals, Inc. Microwave Opt Technol Lett 44: 247–249, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.20600
📜 SIMILAR VOLUMES
## Abstract A novel dual‐mode band‐pass filter with a cross‐shaped resonator and three ring resonators has been designed and implemented. The proposed structure is different from the conventional dual‐mode band‐pass filter. The designed dual‐mode band‐pass filter has a very sharp attenuation rate b
## Abstract In this article, a bandpass filter with a wide stopband is proposed for the wireless local area network (WLAN) system. The filter is mainly composed of a dual‐mode bandpass filter (DM‐BPF) and a controllable bandstop structure (CBS). By using the CBS, multiple transmission zeros can be
## Abstract A dual‐mode bandpass filter (BPF) using the degenerate modes of a meander square‐ring structure printed on the high‐permittivity substrate is proposed. The dual‐mode resonator is based on a square‐ring loaded with two meander strips at the coupling sides. The filter is printed on the Al
## Abstract A novel microstrip bandpass filter using a dual‐mode square‐ring resonator is presented in this paper, in which the input/output microstrip lines are arranged under the square‐ring to improve the coupling between the microstrip lines and the square‐ring. The filter has been investigated
## Abstract This article presents a novel miniaturized bandpass filter using a square ring. Each side of the ring is loaded almost at one of the ends with a stub. The stub increases the current path length; bring down the resonance frequency of the ring. The other end of each stub is terminated wit