𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Optically controlled microstrip load and stub on silicon substrate

✍ Scribed by Avanish Bhadauria; Nasimuddin; A. K. Verma; Enakshi Khular Sharma; B. R. Singh

Publisher
John Wiley and Sons
Year
2003
Tongue
English
Weight
133 KB
Volume
39
Category
Article
ISSN
0895-2477

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

In this paper we report the modeling and experimental measurements for optical control of a microstrip load and λ~g~/4 stub fabricated on high‐resistivity silicon substrate. We present the basic circuit model of a photoinduced or optical load created by a laser spot at the end of an open microstrip line. The modeled optical load has been used to simulate reflections at open microstrip line terminated by the optical load. The results obtained by both simulation and measurement show that an optical load created at the open termination of a microstrip line can control the reflection parameter of the line. A similar optical load created at the end of an open λ__g__/4 stub on a microstrip line has been shown to control the transmitted power at the design frequency. The measurement results compare well with those predicted by both a simple circuit simulation and a simulation carried out on the Ansoft Maxwell simulator using a termination obtained by an equivalent circuit model of the optical load. © 2003 Wiley Periodicals, Inc. Microwave Opt Technol Lett 39: 271–276, 2003; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.11188

📜 SIMILAR VOLUMES

3D photo-induced load modeling for optic
3D photo-induced load modeling for optically controlled microwave microstrip line
✍ J.-D. Arnould; R. Gary; A. Vilcot 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 159 KB

## Abstract This paper deals with the 3D modeling of the photo‐induced load created by a laser that illuminates a semiconductor substrate. This independent optical command allows us to change the microwave behavior of the microstrip device. We present a 3D‐equivalent microwave model for the photo‐i

High performance CPW and microstrip ring
High performance CPW and microstrip ring resonators on silicon substrates
✍ C. C. Chen; B. F. Hung; Albert Chin; S. P. McAlister 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 151 KB

## Abstract High performance CPW and novel microstrip ring resonators at ∼30 GHz and 40 GHz have been fabricated on Si substrates, using an optimized proton‐implantation process. Very good insertion loss and resonator characteristics, close to those from ideal electro‐magnetic simulations, were mea

Optically controlled coplanar waveguide
Optically controlled coplanar waveguide phase shifter on silicon
✍ B. Cabon; S. Chouteau; S. Wloczysiak; A. Vilcot; J. Boussey 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 127 KB

Figure 3 Measured return loss for dual-frequency operation; s r 4.4, h s 1.6 mm, w s 1 mm, d s 16 mm, l s 14 mm y Figure 4 Measured E-plane and H-plane radiation patterns for the dual-frequency operation with l s 12 mm. Other parameters are x given in Figure 3 ## 3. Conclusions A single-feed, redu

Frequency-dependent expressions for indu
Frequency-dependent expressions for inductance and resistance of microstrip line on silicon substrate
✍ H. Ymeri; B. Nauwelaers; Karen Maex; D. De Roest; S. Vandenberghe 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 308 KB

## Abstract A new closed‐form expression to calculate frequency‐dependent distributed inductance and the associated distributed series resistance of microstrip lines on a lossy silicon substrate (CMOS technology) are presented. The proposed analytic model for series impedance is based on a self‐con

Structure and optical properties of poro
Structure and optical properties of porous silicon prepared on thin epitaxial silicon layer on silicon substrates
✍ M. Balarin; O. Gamulin; M. Ivanda; V. Djerek; O. Celan; S. Music; M. Ristic; K. 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 743 KB

Porous silicon (PSi) samples were prepared by electrochemical etching of silicon-on-insulator wafers, consisting of 45 m thick p-type (111) silicon epitaxial layer grown on a thin 100 nm SiO 2 layer on silicon substrates, by varying the concentration of 48% HF in ethanol solution. Within the epitaxi

Improved circuit model for coplanar-wave
Improved circuit model for coplanar-waveguide to microstrip-line transition on silicon substrate
✍ Qi Hua; Wen-Yan Yin; Liang Zhou; Jun-Fa Mao; Kai Kang; Lei Zhu 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 294 KB

## Abstract An improved equivalent circuit model is proposed to accurately characterize a metal via transition, between a finite ground coplanar waveguide (FGCPW) and a finite ground thin film microstrip line (FGTFML), which was fabricated using standard CMOS technology. This circuit model with onl