coherent Ar ϩ laser beams with identical intensity ( ϭ 488 nm, the total intensity is 400 mW/cm 2 ) incident into photorefractive crystal at 2 ϭ 20°in the sample, in which the c-axis was oriented to be in the incident plane and perpendicular to the bisector of the two beams. An incoherent He-Ne lase
K-band single balanced mixer for ultra-wideband radar in 0.18-μm CMOS technology
✍ Scribed by Han-Yeol Yu; Sung-Sun Choi; Sung-Hyun Kim; Yong-Hoon Kim
- Publisher
- John Wiley and Sons
- Year
- 2007
- Tongue
- English
- Weight
- 192 KB
- Volume
- 49
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
A K‐band single balanced mixer for ultra‐wideband radar using a 0.18‐μm CMOS technology is presented. The designed mixer was applied to LC ladder matching technique on RF port and Marchand type balun with slot pattern ground on LO port for wideband operation, respectively. The mixer achieves 3‐dB bandwidth of 1.4 GHz, power conversion gain of 1.2 dB, and 1‐dB compression point of −3 dBm at RF frequency of 24 GHz and LO frequency of 24.1 GHz. © 2007 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 2697–2700, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22872
📜 SIMILAR VOLUMES
## Abstract This article presents an ultra‐wideband (UWB). RF receiver that includes a low noise amplifier (LNA) and a single‐balanced mixer (SBM). The LNA uses an RC shunt feedback technique for broadening the bandwidth. Besides, an inductor is used as an interstage match at the cascode LNA that e
## Abstract This article presents an effective methodology for designing a CMOS single‐balanced down conversion mixer with LO cancellation for MB‐OFDM UWB direct‐conversion receiver. The most crucial drawback of single‐balanced mixer; LO feedthrough is overcome by employing BPF technique for multi‐
## Abstract A K‐band low‐noise amplifier (LNA) was realized in a standard 0.18‐μm CMOS technology. The cascaded common‐source configuration of four stages was adopted for low voltage operation and high gain performance. In addition, the gate‐source transformer feedback technique was employed to ach
## Abstract A concurrent 2.4/5.2‐GHz dual‐band monolithic low‐noise amplifier implemented with a 0.18‐μm mixed‐signal CMOS technology is reported for the first time. This LNA only consumed 3‐mW power, and achieved minimum noise figures of 3.3 and 3.26 dB and 2.4 and 5.2 GHz, respectively. Input and