## Abstract A novel design of a dual‐mode resonator with double‐ring structure for a band‐pass filter is presented in this paper. Voltage/current couplings between the two rings are proposed based on a mode chart. Because each ring exhibits dual‐mode responses, they determine the range of operation
Dual mode ring resonator band-pass filter with wide stopband
✍ Scribed by Mrinal Kanti Mandal; Subrata Sanyal
- Publisher
- John Wiley and Sons
- Year
- 2006
- Tongue
- English
- Weight
- 319 KB
- Volume
- 48
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
In this article, parallel‐coupled microstrip line (PCML) with ground plane aperture is used to improve the stopband performance of a stub tuned dual mode ring resonator band‐pass filter (BPF). The PCML with ground plane structure produces a wide‐band band‐pass response, whereas the stub tuned dual mode ring resonator produces sharp cutoff. The combined filter produces vastly improved filter characteristics. A prototype fabricated BPF having passband center frequency 5.71 GHz has a bandwidth of 40.6%. The upper stopband is extended over 6 GHz and there is no undesirable passband on the lower side of the main passband. Skirt selectivity of a single stage filter is at least 120 dB/GHz. © 2006 Wiley Periodicals, Inc. Microwave Opt Technol Lett 48: 2216–2218, 2006; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.21934
📜 SIMILAR VOLUMES
## Abstract A compact microstrip dual‐plane resonant cell structure is presented. Good lowpass performance and wide stopband characteristics can be obtained with a simple single resonant cell; multiple resonant modes are introduced in the stopband, thus rejection width is significantly improved. Me
## Abstract A novel dual‐mode band‐pass filter with a cross‐shaped resonator and three ring resonators has been designed and implemented. The proposed structure is different from the conventional dual‐mode band‐pass filter. The designed dual‐mode band‐pass filter has a very sharp attenuation rate b
## Abstract In this article, a compact dual‐mode patch resonator for band‐pass filter applications is developed. The size reduction of the studied filter is simply achieved by etching a dual‐cross slot on the patch. Studies indicate that with this arrangement, the size can be reduced to 26.7% as co
## Abstract A novel compact microstrip low‐pass filter (LPF) is proposed using open circuit stubs and square patches alongwith complementary split ring resonator (CSRR). It exhibits wide stopband and sharp rejection. A demonstration LPF, having 3‐dB cutoff frequency of 1.45 GHz, was fabricated and
We present the development of a miniaturized broadband Wilkinson power divider on a multilayer organic substrate with integrated thin film resistors. The VSWR for all port for both dividers is better than 1.6:1, the excess insertion loss is less than 1.6 dB up to 18 GHz, and 12 dB of isolation is re