## Abstract A novel design of a dual‐mode resonator with double‐ring structure for a band‐pass filter is presented in this paper. Voltage/current couplings between the two rings are proposed based on a mode chart. Because each ring exhibits dual‐mode responses, they determine the range of operation
Dual-mode double-ring resonators for microstrip band-pass-filter applications
✍ Scribed by Liu, J.C.; Lu, P.C.; Shie, C.H.; Cheng, C.S.; Yao, L.
- Book ID
- 114455342
- Publisher
- The Institution of Electrical Engineers
- Year
- 2004
- Tongue
- English
- Weight
- 346 KB
- Volume
- 151
- Category
- Article
- ISSN
- 1350-2417
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
## Abstract The CPW‐fed configurations of dual‐mode ring resonator (DMRR) are introduced to improve the performance of the dual‐mode double ring resonator (DMDRR). To obtain low insertion loss (1.65 dB at TM~110~ mode and 0.91 dB at TM~210~ mode) and high out‐of‐band rejection level (−51.95 dB) and
## Abstract The novel configurations of dual‐mode double slot‐ring resonator (DMDSRR) are introduced to improve the performance of the dual‐mode double‐ring resonator (DMDRR). To obtain a lower insertion loss (−0.76 dB) higher rejection (−48.21 dB) and wider band (BW about 93.35%) filters using tre
## Abstract In this article, parallel‐coupled microstrip line (PCML) with ground plane aperture is used to improve the stopband performance of a stub tuned dual mode ring resonator band‐pass filter (BPF). The PCML with ground plane structure produces a wide‐band band‐pass response, whereas the stub