𝔖 Bobbio Scriptorium
✦   LIBER   ✦

An algebraic method for noise parameter analysis of temperature noise models

✍ Scribed by Mikael Garcia; Jörgen Stenarson; Herbert Zirath; Ilcho Angelov

Publisher
John Wiley and Sons
Year
1998
Tongue
English
Weight
116 KB
Volume
17
Category
Article
ISSN
0895-2477

No coin nor oath required. For personal study only.

✦ Synopsis

A new method for calculation of the noise parameters of arbitrary temperature noise circuits is presented. The method is straightforward and related to nodal analysis of networks. For demonstration purposes, the method is applied to a frequently used temperature noise model for an intrinsic FET.

📜 SIMILAR VOLUMES

An internal reference model–based PRF te
An internal reference model–based PRF temperature mapping method with Cramer-Rao lower bound noise performance analysis
✍ Cheng Li; Xinyi Pan; Kui Ying; Qiang Zhang; Jing An; Dehe Weng; Wen Qin; Kunchen 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 494 KB

## Abstract The conventional phase difference method for MR thermometry suffers from disturbances caused by the presence of lipid protons, motion‐induced error, and field drift. A signal model is presented with multi‐echo gradient echo (GRE) sequence using a fat signal as an internal reference to o

Extraction of an avalanche diode noise m
Extraction of an avalanche diode noise model for its application as an on-wafer noise source
✍ M. C. Maya; A. Lázaro; L. Pradell 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 138 KB

## Abstract This paper presents a method to characterize the excess noise ratio (ENR) of an unmatched avalanche noise diode for application as an on‐wafer noise source. It is based on the determination of a broadband device noise circuit‐model from its measured reflection coefficient and noise powe

A simple method for the determination of
A simple method for the determination of noise coefficients P, R, and C by two port noise parameters
✍ Ping-Yu Chen; Shey-Shi Lu; Huei Wang 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 158 KB

In this paper, a simple method for the determination of noise coefficients P, R, and C by standard two-port noise parameters, F min , R N and ⌫ opt is presented. The relation between equivalent noise resistance R N and equivalent noise conductance g n has been derived, which greatly simplifies the e

Model case analysis of an algebraic mult
Model case analysis of an algebraic multilevel method
✍ Yair Shapira 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 166 KB 👁 1 views

A multilevel method for the solution of sparse linear systems is introduced. The method is defined in terms of the coefficient matrix alone; no underlying PDE or mesh is assumed. An upper bound for the condition number is available for a class of SPD problems. In particular, for certain discretizati

A method for the determination of a dist
A method for the determination of a distributed FET noise model based on matched-source noise-figure measurements
✍ M. C. Maya; A. Lázaro; L. Pradell 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 131 KB 👁 1 views

## Abstract A new method for the determination of a distributed FET noise model is presented. It is based on the extraction of the intrinsic noise‐correlation matrix of an elemental section of the device from the device's noise figure, measured for only one source‐impedance state at a number of fre

Analysis of scattering parameters and th
Analysis of scattering parameters and thermal noise of a MOSFET for its microwave frequency applications
✍ Anisha Goswami; Mridula Gupta; R. S. Gupta 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 237 KB

## Abstract A fringing field‐effect‐dependent MOSFET equivalent‐circuit model for its microwave frequency applications has been developed. The thermal noise performance of the device has also been analyzed, including the distributed gate. The equivalent‐current noise source takes into account the t