Adaptive synthesis and design of resonator filters with source/load-multiresonator coupling
✍ Scribed by Amari, S.; Rosenberg, U.; Bornemann, J.
- Book ID
- 114659606
- Publisher
- IEEE
- Year
- 2002
- Tongue
- English
- Weight
- 311 KB
- Volume
- 50
- Category
- Article
- ISSN
- 0018-9480
No coin nor oath required. For personal study only.
📜 SIMILAR VOLUMES
## Abstract A novel triple‐mode square loop microstrip filter with capacitive open stubs and source‐load coupling is proposed.The filter has three controllable transmission zeros near its passband, and exhibits sharp skirt property. The bandpass filter is fabricated and measured. Both simulated and
## Abstract An extension is made to the synthesis of microwave filters with cross couplings between nonadjacent cavities to the case where there is a direct coupling between the input and output ports, i.e., the source and the load of the device. This coupling extends to __N__‐order filters the pos
## Abstract A novel transversal bandpass filter is proposed in this letter. Different from conventional two‐order planar transversal filter, the proposed filter is a three‐order planar transversal filter by incorporating microstrip dual‐mode open‐loop resonator and slot line resonator. Furthermore,
## Abstract In this article, a novel multilayer second‐order coupled‐resonator bandpass filter with harmonics suppression is proposed to improve the stopband characteristics. The proposed filter has been implemented in a five‐layer configuration using multilayer PCB technology. The measured results
## Abstract This paper describes the design of a narrow bandpass filter with attenuation poles used at high frequencies. The filter circuit is new and consists of coupled lines and resonators. This paper analyzes how the filter characteristics vary with these circuit parameters. A bandpass filter d