✦ LIBER ✦

Stress measurement in alumina scales on high temperature alloys using X-ray stress evaluation and laser Raman spectroscopy

✍ Scribed by V. R. Vosberg; W. Fischer; M. G. Berger; D. Clemens; W. J. Quadakkers; H. Nickel

Book ID: 113022474
Publisher: Springer
Year: 1996
Tongue: English
Weight: 108 KB
Volume: 355
Category: Article
ISSN: 1618-2650
DOI: 10.1007/s0021663550745

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Stresses in alumina scales on high-tempe

Stresses in alumina scales on high-temperature alloys measured by X-ray and optical methods

✍ V. R. Vosberg; D. Clemens; M. G. Berger; W. J. Quadakkers; W. Fischer; H. Nickel 📂 Article 📅 1997 🏛 Springer 🌐 English ⚖ 143 KB

Simultaneous measurement of temperature

Simultaneous measurement of temperature and thermal stress in AlGaN/GaN high electron mobility transistors using Raman scattering spectroscopy

✍ T. Batten; J. W. Pomeroy; M. J. Uren; T. Martin; M. Kuball 📂 Article 📅 2009 🏛 American Institute of Physics 🌐 English ⚖ 277 KB

Ex-Situ Stress Measurements in Polycryst

Ex-Situ Stress Measurements in Polycrystalline Ceramics Using Photo-Stimulated Luminescence Spectroscopy and High-Energy X-Rays

✍ Seetha Raghavan; Peter K. Imbrie 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 339 KB

Deformation experiments using synchrotro

Deformation experiments using synchrotron X-rays: in situ stress and strain measurements at high pressure and temperature

✍ Jiuhua Chen; Li Li; Donald Weidner; Michael Vaughan 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 351 KB

Depth Profile of Titanium Alloy (Ti-6Al-

Depth Profile of Titanium Alloy (Ti-6Al-4V) and Residual Stress Measured by Using X-Ray Diffraction after Metal Cutting Assisted by High-Pressured Jet Cooling Evaluation of Etching Methods: ION Beam (EDOS) and Electro-Chemical Etching

✍ Vosough, Manoucheh; Liu, Ping; Svenningsson, Inge 📂 Article 📅 2005 🏛 Trans Tech Publications, Ltd. 🌐 English ⚖ 223 KB

Influence of the mode of introduction of

Influence of the mode of introduction of a reactive element on the high temperature oxidation behavior of an alumina-forming alloy. Part III: The use of two stage oxidation experiments and in situ X-ray diffraction to understand the oxidation mechanisms

✍ S. Chevalier; C. Issartel; R. Cueff; H. Buscaif; G. Strehl; G. Borchardt 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 German ⚖ 476 KB

The aim of this work was to investigate several different yttrium introduction routes to improve the high temperature oxidation resistance of a Fe-20Cr-5Al model alloy. Y 2 O 3 sol-gel coatings, Y 2 O 3 metal-organic chemical vapor deposition (MOCVD) coatings, yttrium ion implantation and yttrium as