𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Reflection L-band erbium-doped fiber-amplifier-based on a fiber-loop mirror

✍ Scribed by Hongyun Meng; Yange Liu; Weiqing Gao; Hao Zhang; Shuzhong Yuan; Xiaoyi Dong


Publisher
John Wiley and Sons
Year
2003
Tongue
English
Weight
100 KB
Volume
36
Category
Article
ISSN
0895-2477

No coin nor oath required. For personal study only.

✦ Synopsis


Abstract

A novel reflection L‐band erbium‐doped fiber amplifier, based on a fiber loop mirror, is constructed. This amplifier reflects the backward ASE to the EDF as a secondary pumping source. A gain of 30 dB (an increase of 6 dB) is obtained, compared to the forward‐end‐pumped EDFA in the range of 1570–1603 nm. The saturated output power was 7.63 dBm and 7.6 dBm for 1580 nm and 1600 nm signals, with increases of 2.98 dB and 3 dB, respectively, compared to the forward end‐pumped EDFA. © 2003 Wiley Periodicals, Inc. Microwave Opt Technol Lett 36: 501–503, 2003; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.10803


📜 SIMILAR VOLUMES


L-band erbium doped fiber amplifier base
✍ Peter D. Dragic 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 161 KB

## Abstract We present a single‐pass L‐band erbium doped fiber amplifier (EDFA) based on a large mode area (LMA) fiber. A single transverse mode is maintained through restricted mode launch. Pump light near 974 nm is sent into the core and has high spatial overlap with the signal beam, helping to p

L-band all-optical gain-clamped erbium-d
✍ Hao Zhang; Qingying Dou; Yanli Jin; Tuan Guo; Lihui Liu; Yange Liu; Shuzhong Yua 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 English ⚖ 94 KB

## Abstract We present an L‐band all‐optical gain‐clamped erbium‐doped fiber amplifier with a fiber‐loop mirror as the ASE reflector. By using the combination of a C/L‐band wavelength division multiplexer (WDM) and fiber‐loop mirror, the backward C‐band amplified spontaneous emission (ASE) is refle

Demonstration of a highly efficient L-ba
✍ Z. G. Lu; F. G. Sun; P. Lin; C. P. Grover 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 271 KB

## Abstract A novel L‐band fiber amplifier comprised of two sections of erbium‐doped fiber (EDF) and an optical reflector is used to enhance power‐conversion efficiency (PCE). We also examine how an optical amplifier can be used without an optical reflector while nonetheless making effective use of

An overview on S-band erbium-doped fiber
✍ S. W. Harun; K. Dimyati; K. K. Jayapalan; H. Ahmad 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 146 KB

An erbium-doped fiber amplifier (EDFA) for S-band signal amplification is designed by using a depressed cladding erbium-doped fiber (DC-EDF). The fiber's characteristics are described in terms of the effects of the fiber spooling diameter on the amplifier's performance. In this experiment, the spool

Multiwavelength erbium-doped fiber ring
✍ Y. Liu; D. Liu; H. Wang 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 268 KB

## Abstract We propose and experimentally demonstrate a multiwavelength erbium‐doped fiber ring laser using a fiber Sagnac loop filter. The fiber Sagnac loop filter served as the wavelength selection component within the ring laser cavity. By carefully tuning the setting of the polarization control

Two-stage S-band erbium-doped fiber ampl
✍ S. W. Harun; N. K. Saat; H. Ahmad 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 English ⚖ 84 KB

## Abstract A two‐stage short‐wavelength‐band erbium‐doped fiber amplifier (S‐band EDFA) is demonstrated using a depressed‐cladding erbium‐doped fiber (EDF). The EDF has a fundamental‐mode cutoff wavelength of about 1525 nm in order to suppress amplified spontaneous emission at the longer wavelengt