## Abstract This paper describes the use of coupled LC‐GC for the determination of organochlorine pesticide residues in fat samples. Organochlorine pesticide residues are preseparated from fat by LC on a short C‐18 column using an organic solvent as the mobile phase. Evaporation of the LC eluent is
On-line LC-GC method for determination of isomers of nervonic acid in meat-derived food
✍ Scribed by Robertino Barcarolo; Andrea Bau; Josefa Barrero Moreno; Burya Dimitrova; Elke Anklam
- Publisher
- John Wiley and Sons
- Year
- 2003
- Tongue
- English
- Weight
- 238 KB
- Volume
- 26
- Category
- Article
- ISSN
- 1615-9306
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
An on‐line liquid chromatography‐gas chromatography (LC‐GC) method for determination of the cis/trans isomers of nervonic acid in meat‐derived food is described. The technique used a home‐assembled LC‐GC coupled system. A simple LC clean‐up procedure using an analytical gel permeation (5 μm) column and 1% ethyl acetate in hexane as mobile phase has proved to be suitable for the isolation and purification of fatty acid methyl esters from the meat matrix. Use of a silica gel (5 μm) pre‐column improved the separation of cis/trans nervonic acid from cholesterol and the more polar constituents of the extracted fraction. GC analyses were performed using a non‐polar GC column and mass spectrometry (MS) for identification of the analytes and flame ionization detector (FID) for quantification of the compounds studied. Excellent linearity with correlation coefficients higher than 0.999 in the range of 0.05–10 μg mL^–1^ nervonic acid and a good repeatability with relative standard deviation (RSD) values generally lower than 4% was obtained. The method developed provides a high sensitivity for trace analysis of the cis/trans isomers of nervonic acid and enables complete automation.
📜 SIMILAR VOLUMES
## Abstract A simple, selective and rapid analytical method for determination of trimethoprim (TMP) in honey samples was developed and validated. This method is based on a SPE technique followed by HPLC with photodiode array detection. After dilution and filtration, aliquots of 500 μL honey samples