✦ LIBER ✦

Numerical and experimental simulation of pass rolling

✍ Scribed by P. Macura; J. Petruska

Publisher: Elsevier Science
Year: 1996
Tongue: English
Weight: 482 KB
Volume: 60
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(96)02307-2

No coin nor oath required. For personal study only.

✦ Synopsis

Numerical and experimental analysis of a stress state in the deformation zone during pass rolling is presented and compared. Obtained results are used for assessment of formability under given geometrical and thermodynamical conditions.

📜 SIMILAR VOLUMES

Rolling-deformation characteristics of c

Rolling-deformation characteristics of clad materials determined by model experiment and numerical simulation: experimental rolling tests using plasticine

✍ Akio Segawa; Takao Kawanami 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 304 KB

Reptation and tube renewal: Experimental

Reptation and tube renewal: Experimental and numerical simulation

✍ G. Marin; J.P. Montfort; Ph. Monge 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 794 KB

Comparison of a numerical analysis of ro

Comparison of a numerical analysis of rolling with experimental data

✍ Ann Bettina Richelsen 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 823 KB

A comparison between numerical results obtained by using the finite-element method and experimentally obtained results for cold plate rolling found in the literature is presented here. The material parameters are chosen as representative of the aluminum material employed in these experiments. A fric

Numerical simulation of wheel rolling ov

Numerical simulation of wheel rolling over rail at high-speeds

✍ Jiang Xiaoyu; Jin Xuesong 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 525 KB

In the paper, a contact element method was used to analyze a wheel rolling over a rail at high-speeds. The rolling contact of the wheel and rail was considered as a two-dimensional rolling contact in a pure rolling and steady state. The loads applied to the wheel are the different axle-loads of trai

Numerical investigation of austenite gra

Numerical investigation of austenite grain size distribution in square-diamond pass hot bar rolling

✍ H.-W. Lee; H.-C. Kwon; Y.-T. Im; P.D. Hodgson 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 769 KB

In this study, the austenite grain size (AGS) for hot bar rolling of AISI4135 steel was predicted based on two different AGS evolution models available in the literature. In order to predict the AGS more accurately, both models were integrated with a three-dimensional non-isothermal finite element p

On the parametric rolling of ships using

On the parametric rolling of ships using a numerical simulation method

✍ B.C. Chang 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 779 KB

This paper has shown a numerical motion simulation method which can be employed to study on parametric rolling of ships in a seaway. The method takes account of the main nonlinear terms in the rolling equation which stabilize parametric rolling, including the nonlinear shape of the righting arm curv