𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Reptation and tube renewal: Experimental and numerical simulation

✍ Scribed by G. Marin; J.P. Montfort; Ph. Monge

Publisher
Elsevier Science
Year
1987
Tongue
English
Weight
794 KB
Volume
23
Category
Article
ISSN
0377-0257

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Numerical simulation of convergent and d
Numerical simulation of convergent and divergent tapered pulse tube cryocoolers and experimental verification
✍ He Yaling; Gao Chengming; Xu Mingyao; Chen Zhongqi; Tao Wenquan πŸ“‚ Article πŸ“… 2001 πŸ› Elsevier Science 🌐 English βš– 241 KB

In this paper, two models were introduced with the governing equations to simulate two kinds of tapered pulse tube cryocoolers. The simulation results were in good agreement with the results of respective experiments. It was also found that there was an optimum cone angle for tapered pulse tube cryo

Numerical and experimental simulation of
Numerical and experimental simulation of pass rolling
✍ P. Macura; J. Petruska πŸ“‚ Article πŸ“… 1996 πŸ› Elsevier Science 🌐 English βš– 482 KB

Numerical and experimental analysis of a stress state in the deformation zone during pass rolling is presented and compared. Obtained results are used for assessment of formability under given geometrical and thermodynamical conditions.

Experimental and Numerical Study of Expa
Experimental and Numerical Study of Expanded Aluminum and Steel Tubes
✍ A.C. Seibi; I. Barsoum; A. Molki πŸ“‚ Article πŸ“… 2011 πŸ› Elsevier 🌐 English βš– 769 KB

This paper presents the design of an experimental set-up to mechanically expand aluminum and steel tubes using conical hardened steel mandrels. The experimental study considered four radial expansion ratios of 10, 15, 20 and 25% and three mandrel angles of 10, 22.5, and 30 degrees. The effect of the