๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Modeling of the bending strain dependence of the critical current in Bi2223/Ag composite tapes based on the damage stress of the superconducting filament

โœ Scribed by Xiaofan Gou; Qiang Shen

Book ID
113850728
Publisher
Elsevier Science
Year
2012
Tongue
English
Weight
477 KB
Volume
475
Category
Article
ISSN
0921-4534

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Influence of delamination location on me
Influence of delamination location on mesoscopic stress state and critical current under bending deformation in Bi2223/Ag superconducting composite tapes
โœ M. Hojo; M. Nakamura; M. Tanaka; T. Adachi; M. Sugano; S. Ochiai; K. Osamura ๐Ÿ“‚ Article ๐Ÿ“… 2005 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 250 KB

The strain dependence of the critical current, I c , of Bi2223/Ag/Ag-alloy composite superconducting tapes has been studied both experimentally and analytically under bending deformation. The microscopic observation after bending deformation indicated that delamination existed inside Bi2223 filament

The effect of post-annealing on the crit
The effect of post-annealing on the critical current recovery of bending-deformed (Bi,Pb)-2223/Ag tapes
โœ L. Zhao; L. Xie; P. Li; T.-M. Qu; Y. Song; X.-C. Wang; Z. Han ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 648 KB

Bi,Pb)-2223/Ag tape fabricated by PIT methods is a promising candidate for electrical power application. In these applications, the tape often undergoes a winding process, which leads to the degradation of the critical current. In this paper, we report the effect of postannealing on the critical cur

Comparison of bending strain effect on t
Comparison of bending strain effect on the critical current degradation of Bi-2223 tapes through different measurement techniques
โœ Hyung-Seop Shin; John R.C. Dizon; Kazumune Katagiri; Tsuneo Kuroda ๐Ÿ“‚ Article ๐Ÿ“… 2006 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 247 KB

Unlike in the tests under tension, transverse compression and torsion, the bending test of HTS tapes requires lots of time and effort since the sample should be bent or mounted successively onto sample holders having different bending radius at room temperature, and then cooled down to measure the c