✦ LIBER ✦

Microstructure and mechanical properties of spray co-deposited Al–8.9 wt.% Si–3.2 wt.% Cu–0.9 wt.% Fe + (Al–3 wt.% Mn–4 wt.% Si)p composite

✍ Scribed by L.A. Bereta; C.F. Ferrarini; W.J. Botta F; C.S. Kiminami; C. Bolfarini

Book ID: 116601087
Publisher: Elsevier Science
Year: 2007
Tongue: English
Weight: 646 KB
Volume: 434-435
Category: Article
ISSN: 0925-8388
DOI: 10.1016/j.jallcom.2006.08.156

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Microstructural analysis of thermally in

Microstructural analysis of thermally induced and deformation induced martensitic transformations in Fe–12.5 wt.% Mn–5.5 wt.% Si–9 wt.% Cr–3.5 wt.% Ni alloy

✍ T. Kirindi; M. Dikici 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 759 KB

Pore filling in graphite particle compac

Pore filling in graphite particle compacts infiltrated with Al–12 wt.%Si and Al–12 wt.%Si–1 wt.%Cu alloys

✍ A. Rodríguez-Guerrero; J.M. Molina; F. Rodríguez-Reinoso; J. Narciso; E. Louis 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 598 KB

The drainage curves (saturation versus applied pressure) that characterize pressure infiltration of Al-12 wt.%Si and Al-12 wt.%Si-1 wt.%Cu alloys into particulate preforms made out of carbon particles of three sizes have been determined. The results show that, no matter the alloy or the particle pre

Magnetic properties evaluation of spray

Magnetic properties evaluation of spray formed and rolled Fe–6.5 wt.% Si–1.0 wt.% Al alloy

✍ A.H. Kasama; C. Bolfarini; C.S. Kiminami; W.J. Botta Filho 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 310 KB

Microstructure and adhesion strength of

Microstructure and adhesion strength of Sn–9Zn–1.5Ag–xBi (x = 0 wt% and 2 wt%)/Cu after electrochemical polarization in a 3.5 wt% NaCl solution

✍ Wang-Long Li; Ying-Ru Chen; Kuo-Ming Chang; Chih-Yao Liu; Min-Hsiung Hon; Moo-Ch 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 938 KB

Investigation on microstructures and pro

Investigation on microstructures and properties of rapidly solidified Mg–6 wt.% Zn–5 wt.% Ca–3 wt.% Ce alloy

✍ T. Zhou; D. Chen; Z.H. Chen; J.H. Chen 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 707 KB

Mechanical alloying of Cu–xCr (x =&

Mechanical alloying of Cu–xCr (x = 3, 5 and 8 wt.%) alloys

✍ C. Aguilar; S. Ordoñez; D. Guzman; P.A. Rojas 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 643 KB

Microstructure and mechanical properties of spray co-deposited Al–8.9&#xa0;wt.% Si–3.2&#xa0;wt.% Cu–0.9&#xa0;wt.% Fe&#xa0;+&#xa0;(Al–3&#xa0;wt.% Mn–4&#xa0;wt.% Si)p composite

Microstructure and mechanical properties of spray co-deposited Al–8.9 wt.% Si–3.2 wt.% Cu–0.9 wt.% Fe + (Al–3 wt.% Mn–4 wt.% Si)p composite