✦ LIBER ✦

Manufacturing complexity evaluation at the design stage for both machining and layered manufacturing

✍ Scribed by O. Kerbrat; P. Mognol; J.-Y. Hascoet

Publisher: Elsevier
Year: 2010
Tongue: English
Weight: 744 KB
Volume: 2
Category: Article
ISSN: 1755-5817
DOI: 10.1016/j.cirpj.2010.03.007

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

A model for evaluating a design change a

A model for evaluating a design change and the distributed manufacturing operations in a collaborative manufacturing environment

✍ Yuan-Jye Tseng; Yu-Wen Kao; Feng-Yi Huang 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 726 KB

Software and hardware design of a roboti

Software and hardware design of a robotic manipulator for the manufacture of complex shaped dies

✍ M.T. Bhatti; M.S.J. Hashmi 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 794 KB

The design, implementation and evaluatio

The design, implementation and evaluation of a diagnostic expert system for the work order procedure for small manufacturing companies

✍ Kristin Kennedy; David Shao 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 452 KB

Concepts and procedures of work psycholo

Concepts and procedures of work psychology for the analysis, evaluation and design of advanced manufacturing systems: A case study

✍ Eberhard Ulich; Heinz Schüpbach; Axel Schilling; Julia K. Kuark 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 818 KB

The design and manufacture of ceramic va

The design and manufacture of ceramic vacuum chambers for the electron synchrotron at DESY, Hamburg: W F Gibbons, Ferranti Limited, Wythenshawe, Manchester, England

📂 Article 📅 1968 🏛 Elsevier Science 🌐 English ⚖ 120 KB

9437746 Concurrent engineering for the n

9437746 Concurrent engineering for the new VQ engine: Productivity evaluation method and design for manufacturability: Hiroshi Onitsuka, Kaoru Eguchi, Naoaki Miura, Hiroatsu Matsumura (Nissan Motor Co., Ltd), pp. 189–192, 9 figs

✍ Onitsuka, H 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 128 KB

The authors have investigated the possibility of developing cvcn lighter connecting rods while maintaining good productivity. As a result. a new lightweight connecting rod has been developed that is made of a low-carbon martensite steel. Because this material does not require tempering, buckling str