๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Linear elastic analysis of semi-elliptical axial surface cracks in a hollow cylinder

โœ Scribed by W. Schmitt; E. Keim

Publisher
Elsevier Science
Year
1979
Tongue
English
Weight
434 KB
Volume
7
Category
Article
ISSN
0308-0161

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Stress intensity factors in a hollow cyl
Stress intensity factors in a hollow cylinder containing a circumferential semi-elliptical crack subjected to combined loading
โœ A.R. Shahani; S.E. Habibi ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 672 KB

The problem of mixed mode fracture induced by a semi-elliptical circumferential crack lying at the outer surface of the cross-section of a hollow cylinder is considered. The cylinder is under the action of axial force, bending moment and torsion. To make the results comprehensive, dimensionless anal

T-Stress solutions for a semi-elliptical
T-Stress solutions for a semi-elliptical axial surface crack in a cylinder subjected to mode-I non-uniform stress distributions
โœ Toshiyuki Meshii; Tomohiro Tanaka; Kai Lu ๐Ÿ“‚ Article ๐Ÿ“… 2010 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 800 KB

This paper presents the T-stress solutions (T 11 and T 33 ) for semi-elliptical axial surface cracks in a cylinder subjected to mode-I non-uniform stress on the crack surface. Two cylindrical geometries with inner radius (R i ) to wall thickness (t) ratios R i /t = 5 and 10 were considered. The T-st

Calculation of Stress Intensity Factors
Calculation of Stress Intensity Factors for axial semi-elliptical surface cracks in a pipe with cladding loaded thermally
โœ Dr. H. Grebner ๐Ÿ“‚ Article ๐Ÿ“… 1988 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 427 KB ๐Ÿ‘ 1 views

By means of the weight functions method stress intensity factors were calculated for axial semi-elliptical surface cracks in a pipe with cladding. The component is loaded by a thermoshock. Starting from a stress-free state the inner surface of the cladding is suddenly cooled down. The time-dependent

Subcritical Crack Growth of semi-ellipti
Subcritical Crack Growth of semi-elliptical surface cracks in a turbine rotor
โœ H. Grebner; U. Strathmeier; G. GnirรŸ; W. Herzog ๐Ÿ“‚ Article ๐Ÿ“… 1988 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 255 KB ๐Ÿ‘ 1 views

The subcritical growth of semi-elliptical surface cracks in the front face of a cylindrical disk was calculated. The disk represents a part of a turbine rotor. The stress intensity factors, which are the basis for the calculations presented here, were given in a former paper [l]. The load steps cons