𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of high injection pressures on the internal stress level in injection moulded specimens

✍ Scribed by Josef Kubat; Mikael Rigdahl

Publisher
Elsevier Science
Year
1975
Tongue
English
Weight
431 KB
Volume
16
Category
Article
ISSN
0032-3861

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Temperature-dependent influence of molec
Temperature-dependent influence of molecular orientation and internal stresses on the deformation of injection-molded polypropylene parts
✍ E. Lafranche; J. Pabiot πŸ“‚ Article πŸ“… 1998 πŸ› John Wiley and Sons 🌐 English βš– 265 KB πŸ‘ 2 views

Local orientation measures by infrared dichroism and thermal stress measures by dilatometric analysis of image (DAI) have made it possible to quantify the evolution of the structure versus the thickness of the injected plastic parts. The stiffness local properties on the one hand, and thermal expans

Influence of mold filling rate and gate
Influence of mold filling rate and gate geometry on the modulus of high pressure injection-molded polyethylene
✍ A. Boldizar; J. KubΓ‘t; M. Rigdahl πŸ“‚ Article πŸ“… 1990 πŸ› John Wiley and Sons 🌐 English βš– 487 KB πŸ‘ 1 views

High pressure injection molding of HDPE with relatively high molecular weight is known to give products with significantly increased modulus and strength. The extent of this improvement is reduced when the thickness of the molded sample increases. The present paper is an account of experiments with