𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of high injection moulding pressures on the engineering properties of linear polyethylene

✍ Scribed by K. Djurner; J. Kubát; M. Rigdahl

Publisher
Elsevier Science
Year
1977
Tongue
English
Weight
689 KB
Volume
18
Category
Article
ISSN
0032-3861

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of mold filling rate and gate
Influence of mold filling rate and gate geometry on the modulus of high pressure injection-molded polyethylene
✍ A. Boldizar; J. Kubát; M. Rigdahl 📂 Article 📅 1990 🏛 John Wiley and Sons 🌐 English ⚖ 487 KB 👁 1 views

High pressure injection molding of HDPE with relatively high molecular weight is known to give products with significantly increased modulus and strength. The extent of this improvement is reduced when the thickness of the molded sample increases. The present paper is an account of experiments with

Effect of blending high-pressure low-den
Effect of blending high-pressure low-density polyethylene on the crystallization kinetics of linear low-density polyethylene
✍ Jiameng Kathy Liu; Yoshinobu Nozue; Tatsuhiro Nagamatsu; Satoru Hosoda 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 237 KB 👁 2 views

## Abstract It is well known that the addition of a small amount of high‐pressure low‐density polyethylene (HP‐LDPE) to linear low‐density polyethylene (LLDPE) can improve the optical properties of LLDPE, and LLDPE/HP‐LDPE blend is widely applied to various uses in the field of film. The optical ha