✦ LIBER ✦

Effect of injection pressure and crazing on internal stresses in injection-moulded polystyrene

✍ Scribed by G.J. Sandilands; J.R. White

Publisher: Elsevier Science
Year: 1980
Tongue: English
Weight: 740 KB
Volume: 21
Category: Article
ISSN: 0032-3861
DOI: 10.1016/0032-3861(80)90278-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Influence of high injection pressures on

Influence of high injection pressures on the internal stress level in injection moulded specimens

✍ Josef Kubat; Mikael Rigdahl 📂 Article 📅 1975 🏛 Elsevier Science 🌐 English ⚖ 431 KB

The effect of crystallinity on the prope

The effect of crystallinity on the properties of injection moulded polypropylene and polyacetal

✍ D.G.M. Wright; R. Dunk; D. Bouvart; M. Autran 📂 Article 📅 1988 🏛 Elsevier Science 🌐 English ⚖ 549 KB

Microwave Detection of Defects and Inhom

Microwave Detection of Defects and Inhomogeneities in Low Pressure Injection Moulded β-TCP Ceramic

✍ S.T. Martins; H. Dannheim; H. Hädrich; J. Weinzierl; F.A. Müller; P. Greil 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 208 KB

Temperature-dependent influence of molec

Temperature-dependent influence of molecular orientation and internal stresses on the deformation of injection-molded polypropylene parts

✍ E. Lafranche; J. Pabiot 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 265 KB 👁 2 views

Local orientation measures by infrared dichroism and thermal stress measures by dilatometric analysis of image (DAI) have made it possible to quantify the evolution of the structure versus the thickness of the injected plastic parts. The stiffness local properties on the one hand, and thermal expans

Modeling the Effect of Supply Pressure F

Modeling the Effect of Supply Pressure Fluctuations on Cavitation Processes in Injection Nozzles

✍ W. Yuan; G.H. Schnerr 📂 Article 📅 2002 🏛 John Wiley and Sons ⚖ 583 KB

In this study cavitating flows in an injection nozzle under time-depended inlet pressure are calculated using a dispersed bubble dynamics model. The calculations confirm that a transient rise of the nozzle inlet pressure forces cavitation to recede and a sharp decrease of the injection pressure enha

The effect of shear controlled orientati

The effect of shear controlled orientation in injection moulding on the mechanical properties of an aliphatic polyketone

✍ Gürhan Kalay; Michael J. Bevis 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 762 KB

This article relates to an investigation of injection moulding a new commercial polymer, an aliphatic polyketone (PK). A terpolymer and a 30% glass-filled grade were used as study materials together with an isotactic polypropylene that was used as a basis for comparison. Both conventional injection