Influence of bending rotations on three and four-point bend end notched flexure tests

✍ Scribed by A. Arrese; F. Mujika

• Publisher: Elsevier Science
• Year: 2008
• Tongue: English
• Weight: 286 KB
• Volume: 75
• Category: Article
• ISSN: 0013-7944
• DOI: 10.1016/j.engfracmech.2008.03.012

✦ Synopsis

Delamination Three-point end notched flexure test Four point end notched flexure test Mode II Energy release rate a b s t r a c t It has been experimentally observed that mode II critical energy release rate (G IIC ) values determined by four-point end notched flexure test and three-point end notched flexure test are different for the same material. At the present work correction factors related to bending rotations are introduced to explain the differences between values of G IIC obtained by three point and four point end notched flexure tests.

The bending angle leads to the contact zones between specimen and supports and specimen and load rollers changing in both test configurations. The present analysis has been carried out by the classical beam theory, neglecting shear effects and assuming the hypothesis of small rotated angles. Results show that the relative differences between corrected and uncorrected values of G IIC are greater in the case of four-point end notched flexure than in the case of three-point end notched flexure test.