## Abstract A novel design of a dual‐mode resonator with double‐ring structure for a band‐pass filter is presented in this paper. Voltage/current couplings between the two rings are proposed based on a mode chart. Because each ring exhibits dual‐mode responses, they determine the range of operation
Improved dual-mode double-ring resonator with radial stub for UWB-filter design
✍ Scribed by Ji-Chyun Liu; Ching-Yang Wu; Ming-Hsun Chiang; David Soong
- Publisher
- John Wiley and Sons
- Year
- 2004
- Tongue
- English
- Weight
- 163 KB
- Volume
- 44
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
An improved filter design of a dual‐mode double‐ring resonator with radial stub for ultra‐wideband (UWB) applications is presented in this paper. Based on the double‐ring resonator and adjusted voltage/current couplings, two radial stubs are added to the outer ring in order to construct the band‐pass filter. The dual‐mode double‐ring resonator exhibits wideband responses, and the radial stubs enhance the bandwidth of the operating‐frequency band. Thus, an alternative approach to improve the bandwidth of the conventional dual‐mode double‐ring resonator, is presented. The experimental and simulation results are given and discussed. © 2005 Wiley Periodicals, Inc. Microwave Opt Technol Lett 44: 219–222, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.20593
📜 SIMILAR VOLUMES
## Abstract A novel dual‐mode bandpass filter using a microstrip triangular ring resonator with coupling stubs has been designed and tested. The basic configuration of this novel dual‐mode filter is a triangular ring resonator. Quasi‐L‐shaped I/O arms used as coupling stubs for enhanced coupling ar
## Abstract The CPW‐fed configurations of dual‐mode ring resonator (DMRR) are introduced to improve the performance of the dual‐mode double ring resonator (DMDRR). To obtain low insertion loss (1.65 dB at TM~110~ mode and 0.91 dB at TM~210~ mode) and high out‐of‐band rejection level (−51.95 dB) and
## Abstract In this article, a millimeter‐wave ultra‐wideband (UWB) bandpass filter is proposed and implemented by cascading two dual‐mode square ring resonators loaded with λ~0~/4 and 3λ~0~/4 open tuning stubs, aiming at transmitting the signals in the UWB passband of 22–29 GHz. Formulae based on
## Abstract The CPW‐fed configurations of dual‐mode double‐ring resonator (DMDRR) and double‐square‐loop (DMDSLR) are introduced to achieve the performance of the dual‐band filters. To obtain lower insertion loss, higher out‐of‐band rejection level, and wider band of DMDRR and DMDSLR filters, using