Fabrication and characterization of superconducting (Cu, C)Ba2CuO4±δ thin films
✍ Scribed by Shipra Singh; Y. Tanaka; A. Sundaresan
- Publisher
- Elsevier Science
- Year
- 2007
- Tongue
- English
- Weight
- 236 KB
- Volume
- 466
- Category
- Article
- ISSN
- 0921-4534
No coin nor oath required. For personal study only.
✦ Synopsis
We have investigated the structural modulation and variation of superconducting transition temperature of (Cu, C)Ba 2 CuO 4±d ((Cu, C)-1201) thin films prepared by rf magnetron sputtering on (1 0 0) SrTiO 3 single crystal substrates in the off-axis configuration. Thin films were deposited in a gas mixture of Ar, O 2 and CO 2 where the Ar:O 2 ratio was kept constant at 1:2 with a total pressure of 15 mTorr and CO 2 gas pressure was varied between 1 and 3 mTorr. XRD patterns revealed the formation of high quality thin films with c-axis oriented perpendicular to the plane of the substrate. The value of the c-lattice parameter varied in the range, c = 8.29-8.33 A ˚. These films had a superconducting resistive transition temperature (T c onset) ranging between 25 and 40 K above which, almost all films showed semiconductor like behavior. Superconductivity in (Cu, C)-1201 thin films was further confirmed by the diamagnetic response observed in ac susceptibility measurement.
📜 SIMILAR VOLUMES
Pr 0.4 Ca 0.6 Ba 2 Cu 3 O 7Àd thin films have been grown on SrTiO 3 (STO) substrates by pulsed laser deposition. The dependence of growth orientation and superconducting properties on substrate temperature were studied. As characterized by X-ray diffraction (XRD), good quality c-axis and a-axis orie
HgBa 2 CuO 4+δ and (Ca x La 1-x )(Ba 1.75-x La 0.25+x )Cu 3 O 7±δ superconducting systems were structurally investigated employing Rietveld analysis. The doping of holes in Hg compounds was done by oxygenation and reduction methods. In Ca-La-Ba-Cu-O system the doping of holes was introduced via cati
Epitaxial (TI,Bi)Srl.6Bao.4Ca2Cu309\_ 8 ((T1,Bi)-1223) thin films on (100) single crystal LamlO 3 substrates were successfully synthesized by a two-step procedure. The (TI,Bi)-1223 phase development in both air and argon was systematically investigated by X-ray diffraction. The microstructure and ep
An important correlation of 1223 phase development to film thickness has been found on the films made by laser ablation and post-annealing on (100) LaA103 single crystal substrate. X-ray diffraction (XRD) and transmission electron microscopy (TEM) were used to characterize the 1223 phase development