๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Evaluation of the anisotropy of machined 3D surface topography

โœ Scribed by Cheng-Gui Li; Shen Dong; Guo-Xiong Zhang

Publisher
Elsevier Science
Year
2000
Tongue
English
Weight
144 KB
Volume
237
Category
Article
ISSN
0043-1648

No coin nor oath required. For personal study only.

โœฆ Synopsis

The anisotropy of surface topography has great effect on the functional performance of an engineering surface. In this paper, through the analysis of the profile spectral moments and the surface spectral moments, a quantitative evaluation method is proposed, which is based on the application of fractal geometry theory. Using the 2nd spectral moments and fractal dimension, the anisotropic evaluation parameter L of 3D surface topography is presented. Experimental results indicate that the surface topography machined by finish turning is anisotropic, and the ground surface is isotropic.

๐Ÿ“œ SIMILAR VOLUMES

Evaluation of the root-mean-square wavel
Evaluation of the root-mean-square wavelength of machined 3D surface topography
โœ Cheng-Gui Li; Shen Dong; Guo-Xiong Zhang ๐Ÿ“‚ Article ๐Ÿ“… 1999 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 181 KB

Based on the application of fractal geometry theory, a quantitative evaluation method of root-mean-square wavelength of 3D stochastic surface topography is proposed, by means of the surface spectral moments. Through the FFT of the discrete data of the profile measured by a Talysurf-5 contact stylus

The accuracy of fast 3D topography measu
The accuracy of fast 3D topography measurements
โœ R Ohlsson; A Wihlborg; H Westberg ๐Ÿ“‚ Article ๐Ÿ“… 2001 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 261 KB

One important factor in surface engineering is the evaluation of the surface topography, i.e. measurement and analysis. These measurements of the surface roughness are normally done by stylus instruments and 2D profiles due to available standards. 3D surface topography evaluation is, however, in som