𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Evaluation of structural and adhesive properties of nylon 6 and PTFE alignment films by means of atomic force microscopy

✍ Scribed by G. Padeletti; S. Pergolini; G. Montesperelli; A. D’Alessandro; F. Campoli; P. Maltese

Publisher
Springer
Year
2000
Tongue
English
Weight
202 KB
Volume
71
Category
Article
ISSN
1432-0630

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Frictional, adhesive and mechanical prop
Frictional, adhesive and mechanical properties of polyester films probed by scanning force microscopy
✍ Beake, Ben D.; Leggett, Graham J.; Shipway, Philip H. 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 819 KB

Compositional mapping of a polyester film surface, Mylar D, was performed utilizing a combination of scanning force microscopy techniques. Lateral force microscopy revealed that additives embedded in the surface had a lower coefficient of friction than the surrounding polymeric material. Force-volum

Investigation of Adhesion Properties of
Investigation of Adhesion Properties of Polymer Materials by Atomic Force Microscopy and Zeta Potential Measurements
✍ Petra Weidenhammer; Hans-Jörg Jacobasch 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 164 KB

## MATERIALS AND METHODS AFM and zeta potential measurements were applied in order to investigate the influence of adsorption phenomena on the adhesion A technical, injection molded poly(etheretherketone) behavior of polymer materials. It is shown by means of zeta poten-(PEEK) was investigated, wh

Nanoscale surface electrical properties
Nanoscale surface electrical properties of zinc oxide films investigated by conducting atomic force microscopy
✍ Chang-Feng Yu; Sy-Hann Chen; Wen-Jia Xie; Yung-Shao Lin; Cheng-Yu Shen; Sheng-Jh 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 238 KB

## Abstract In this study, conducting atomic force microscopy was employed to investigate the nanoscale surface electrical properties of zinc oxide (ZnO) films prepared by pulsed laser deposition (PLD) at different substrate temperatures for use as anode materials in polymer light‐emitting diodes.