ZrO 2 catalyst, which is strongly influenced by preparation A series of PO 30 4 /ZrO 2 samples with PO 30 4 loading in the range procedures (8-10) and is very active for n-C 4 isomerization, 2.24 to 37.5 wt% have been prepared (by impregnation of H 3 PO 4 is not relatively stable and undergoes deact
Effect of Supported Na+Ions on the Texture Properties of ZrO2
β Scribed by Zheng Liu; Weijie Ji; Lin Dong; Yi Chen
- Publisher
- Elsevier Science
- Year
- 1998
- Tongue
- English
- Weight
- 280 KB
- Volume
- 138
- Category
- Article
- ISSN
- 0022-4596
No coin nor oath required. For personal study only.
β¦ Synopsis
The dispersion of sodium nitrate on tetragonal zirconia and the effect of the dispersed sodium species on the textural properties of the support are investigated by using XRD, LRS, DTA, and BET surface area measurement. The results indicate that NaNO3 can be dispersed on the surface of tetragonal zirconia by the incorporation of Na Ψ ions into the surface vacant sites. The experimentally measured dispersion capacity of sodium nitrate on t-ZrO2 is consistent with the value deduced from the incorporation model, i.e., 8.6 Na Ψ /nm 2 t-ZrO2. The dispersed Na Ψ ion species can effectively hinder the sintering of zirconia and prevent its phase transformation from tetragonal to monoclinic. The crystallization temperature and surface area of the samples are strongly dependent on the loaded amount of NaNO3 when it is below the dispersion capacity. Crystalline NaNO3 is detected when its loading exceeds the dispersion capacity and has less effect on the structural and textural properties of the t-ZrO2.
π SIMILAR VOLUMES
on this clay in two solvent systems, dimethyl sulfoxide and The specific rate coefficients of adsorption of Cu 2/ on Naacetone, which have not been studied before. These two montmorillonite clay in dimethyl sulfoxide (DMSO) and acetone solvents belong to the dipolar aprotic solvent class and are sol
Mixed ZnO-ZrO 2 films have been obtained by sol-gel technology. By using spin coating method, the films were deposited on Si and glass substrates. The influence of thermal annealings (the temperatures vary from 400 Β°C to 750 Β°C) on their structural properties has been studied. The structural behavio
## Abstract Electrical conductivity has been measured at different temperatures for ZrO~2~ doped with various molar ratios of CuO. The conductivity increases due to migration of vacancies, created by doping. The conductivity was found to increase with increase in temperature till 220 Β°C and thereaf
The effect of activation temperature and phosphate concentration on the catalytic properties of phosphated zirconia (PO 3- 4 /ZrO 2 ) has been described. XRD patterns show that phosphate stabilizes the tetragonal phase of ZrO 2 up to 1000 β’ C but the crystallization temperature is delayed with incre