✦ LIBER ✦

Determination of the radial width of cut and cutting modes in milling

✍ Scribed by S. Hinduja; Y.S. Ma; G. Barrow

Publisher: Elsevier Science
Year: 1995
Tongue: English
Weight: 624 KB
Volume: 35
Category: Article
ISSN: 0890-6955
DOI: 10.1016/0890-6955(95)93038-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Determining of cutting-force components

Determining of cutting-force components in face milling

✍ J. Heikkala 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 295 KB

Determination of the dynamic cutting coe

Determination of the dynamic cutting coefficients for milling

✍ G. Droubi; M.M. Sadek; S.A. Tobias 📂 Article 📅 1973 🏛 Elsevier Science ⚖ 518 KB

The prediction of cutting forces in end

The prediction of cutting forces in end milling with application to cornering cuts

✍ W.A. Kline; R.E. DeVor; J.R. Lindberg 📂 Article 📅 1982 🏛 Elsevier Science ⚖ 846 KB

Estimation of cutting forces in micromil

Estimation of cutting forces in micromilling through the determination of specific cutting pressures

✍ H. Pérez; A. Vizán; J.C. Hernandez; M. Guzmán 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 551 KB

In this paper a new model for the estimation of cutting forces in micromilling based on specific cutting pressure is presented. The proposed model includes three parameters which allow to control the entry of the cutter in the workpiece and which consider also the errors in the radial position of th

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—II. Cut geometry analysis and model verification

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 409 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process

✍ Ching-Chih Tai; Kuang-Hua Fuh 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 974 KB