✦ LIBER ✦

The prediction of cutting forces in the ball-end milling process—II. Cut geometry analysis and model verification

✍ Scribed by Hsi-Yung Feng; Chia-Hsiang Menq

Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 409 KB
Volume: 34
Category: Article
ISSN: 0890-6955
DOI: 10.1016/0890-6955(94)90053-1

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process

✍ Ching-Chih Tai; Kuang-Hua Fuh 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 974 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—I. Model formulation and model building procedure

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 728 KB

This paper presents a model for the prediction of cutting forces in the ball-end milling process. The steps used in developing the force model are based on the mechanistic principles of metal cutting. The cutting forces are calculated on the basis of the engaged cut geometry, the undeformed chip thi

The prediction of the cutting force in b

The prediction of the cutting force in ball-end milling with a flexible cutter

✍ Choonggun Sim; Minyang Yang 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 850 KB

The prediction of cutting forces in end

The prediction of cutting forces in end milling with application to cornering cuts

✍ W.A. Kline; R.E. DeVor; J.R. Lindberg 📂 Article 📅 1982 🏛 Elsevier Science ⚖ 846 KB

The effect of runout on cutting geometry

The effect of runout on cutting geometry and forces in end milling

✍ W.A. Kline; R.E. DeVor 📂 Article 📅 1983 🏛 Elsevier Science ⚖ 870 KB

The prediction of dimensional error for

The prediction of dimensional error for sculptured surface productions using the ball-end milling process. Part 2: Surface generation model and experimental verification

✍ Ee Meng Lim; Chia-Hsiang Menq 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 757 KB