✦ LIBER ✦

The effect of runout on cutting geometry and forces in end milling

✍ Scribed by W.A. Kline; R.E. DeVor

Publisher: Elsevier Science
Year: 1983
Weight: 870 KB
Volume: 23
Category: Article
ISSN: 0020-7357
DOI: 10.1016/0020-7357(83)90012-4

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process

✍ Ching-Chih Tai; Kuang-Hua Fuh 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 974 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—II. Cut geometry analysis and model verification

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 409 KB

The prediction of cutting forces in end

The prediction of cutting forces in end milling with application to cornering cuts

✍ W.A. Kline; R.E. DeVor; J.R. Lindberg 📂 Article 📅 1982 🏛 Elsevier Science ⚖ 846 KB

The prediction of cutting forces in the

The prediction of cutting forces in the ball-end milling process—I. Model formulation and model building procedure

✍ Hsi-Yung Feng; Chia-Hsiang Menq 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 728 KB

This paper presents a model for the prediction of cutting forces in the ball-end milling process. The steps used in developing the force model are based on the mechanistic principles of metal cutting. The cutting forces are calculated on the basis of the engaged cut geometry, the undeformed chip thi

The prediction of the cutting force in b

The prediction of the cutting force in ball-end milling with a flexible cutter

✍ Choonggun Sim; Minyang Yang 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 850 KB

Chatter detection in milling based on th

Chatter detection in milling based on the probability distribution of cutting force signal

✍ Ruxu Du; M.A. Elbestawi; B.C. Ullagaddi 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 776 KB