✦ LIBER ✦

Determining of cutting-force components in face milling

✍ Scribed by J. Heikkala

Publisher: Elsevier Science
Year: 1995
Tongue: English
Weight: 295 KB
Volume: 52
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(94)01429-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Cutting force control of milling machine

✍ Sunan Huang; Kok Kiong Tan; Geok Soon Hong; Yoke San Wong 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 470 KB

Optimal description of the time course o

Optimal description of the time course of the cutting force components in multiaxis milling

✍ K.-D. Bouzakis; G. Kalidaropoulos 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 332 KB

Cutting forces in down milling

✍ A.J.P. Sabberwal 📂 Article 📅 1962 🏛 Elsevier Science ⚖ 575 KB

Three dimensional cutting force analysis

Three dimensional cutting force analysis in end milling

✍ Li Zheng; Yun Shun Chiou; Steven Y. Liang 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 592 KB

Improved modelling of cutting force coef

Improved modelling of cutting force coefficients in peripheral milling

✍ G. Yücesan; Y. Altintaş 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 734 KB

Direct adaptive cutting force control of

Direct adaptive cutting force control of milling processes

✍ C.C.H. Ma; Y. Altintas 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 332 KB

Adaptive control of peak cutting force of a milling system with saturation nonlinearities is addressed. It is shown theoretically and demonstrated through experimental results that, while most adaptive control methodologies in the literature may not be applicable for such a system due to the presenc