✦ LIBER ✦

Cutting force control of milling machine

✍ Scribed by Sunan Huang; Kok Kiong Tan; Geok Soon Hong; Yoke San Wong

Publisher: Elsevier Science
Year: 2007
Tongue: English
Weight: 470 KB
Volume: 17
Category: Article
ISSN: 0957-4158
DOI: 10.1016/j.mechatronics.2007.07.005

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Direct adaptive cutting force control of

Direct adaptive cutting force control of milling processes

✍ C.C.H. Ma; Y. Altintas 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 332 KB

Adaptive control of peak cutting force of a milling system with saturation nonlinearities is addressed. It is shown theoretically and demonstrated through experimental results that, while most adaptive control methodologies in the literature may not be applicable for such a system due to the presenc

Improvement of surface waviness by cutti

Improvement of surface waviness by cutting force control in milling

✍ Chung-Young Jung; Jun-Ho Oh 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 546 KB

Adaptive cutting force control for a mac

Adaptive cutting force control for a machining center by using indirect cutting force measurements

✍ Tae-Yong Kim; Jongwon Kim 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 640 KB

Determining of cutting-force components

Determining of cutting-force components in face milling

✍ J. Heikkala 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 295 KB

Cutting forces in down milling

✍ A.J.P. Sabberwal 📂 Article 📅 1962 🏛 Elsevier Science ⚖ 575 KB

Three dimensional cutting force analysis

Three dimensional cutting force analysis in end milling

✍ Li Zheng; Yun Shun Chiou; Steven Y. Liang 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 592 KB