✦ LIBER ✦

Improvement of surface waviness by cutting force control in milling

✍ Scribed by Chung-Young Jung; Jun-Ho Oh

Publisher: Elsevier Science
Year: 1991
Tongue: English
Weight: 546 KB
Volume: 31
Category: Article
ISSN: 0890-6955
DOI: 10.1016/0890-6955(91)90047-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Improved modelling of cutting force coef

Improved modelling of cutting force coefficients in peripheral milling

✍ G. Yücesan; Y. Altintaş 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 734 KB

Improvement of Dynamic Properties in Mil

Improvement of Dynamic Properties in Milling by Integrated Stepped Cutting

✍ B. Karpuschewski; S. Batt 📂 Article 📅 2007 🏛 International Academy for Production Engineering 🌐 English ⚖ 698 KB

Die and mold machining usually necessitate employment of milling tools with long shanks. However, economic and technical design requirements often enforce low frequency structural vibration characteristics in work-pieces, especially in an area distanced from the tool holder. These structurally unsta

Micro shot blasting of machine tools for

Micro shot blasting of machine tools for improving surface finish and reducing cutting forces in manufacturing

✍ D.M. Kennedy; J. Vahey; D. Hanney 📂 Article 📅 2005 🏛 Elsevier Science ⚖ 874 KB

Feed rate optimization based on cutting

Feed rate optimization based on cutting force calculations in 3-axis milling of dies and molds with sculptured surfaces

✍ Zeki Yazar; Karl-Friedrich Koch; Tom Merrick; Taylan Altan 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 916 KB

The use of CAD/CAM systems and NC machine tools for die and mold manufacturing offers considerable advantages over conventional methods, such as reduction in machining time and costs, and improvements in accuracy and reproducibility. However, the selection of cutting tools and machining strategy and