This paper presents a new dual-frequency design for microstrip patch antennas. The proposed dual-frequency antenna is excited by a single probe feed, and the feed position is on the rectangular patch that is surrounded by a square-ring patch. The rectangular patch not only acts as a coupling-strip f
Design of a dual-mode annular ring antenna with a coupling feed
β Scribed by Jae Hee Kim; Dae Woong Woo; Wee Sang Park
- Publisher
- John Wiley and Sons
- Year
- 2009
- Tongue
- English
- Weight
- 330 KB
- Volume
- 51
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
β¦ Synopsis
Abstract
A dualβmode annular ring antenna for both global positioning system (GPS) and satellite digital multimedia broadcasting (SβDMB) is designed. The proposed antenna consists of a coupling feed line and four slots on an annular ring patch. A gap between the feed line and the annular ring patch is used for an input impedance matching; the slots are used for adjusting the resonant frequency of the TM~21~ mode at the DMB frequency. The antenna was fabricated and measured. The antenna resonates at the GPS and DMB frequencies with suitable bandwidths. It has a broadside radiation pattern in the GPS band and a conical beam radiation pattern in the DMB band. Β© 2009 Wiley Periodicals, Inc. Microwave Opt Technol Lett 51: 3011β3013, 2009; Published online in Wiley InterScience (www.interscience. wiley.com). DOI 10.1002/mop.24796
π SIMILAR VOLUMES
The design of a wideband dual-polarized slot-coupled stacked microstrip antenna with high isolation is introduced. The proposed stacked-patch antenna is excited by both open-ended and T-shaped microstrip lines via two H-shaped slots placed orthogonally so as to improve the isolation between the two
Collected f 0 results are shown in Figure 15. The center frequency varies with s/(s Ο© w g ) ratio around the theoretical value c 0 /(4h g ) Ο 1 GHz. However, it is noted that as the period length decreases (that is, (s Ο© w g )/ G decreases), f 0 depends less on the s/(s Ο© w g ) ratio. The dependence
## Abstract A simplified probe feed input impedance for a rectangular patch antenna based on the Green's function is used to design a dual frequency matched antenna. The predicted results at design frequencies of 1.9 and 2.4 GHz are in close agreement with experimental measurements. Β© 2009 Wiley Pe
## Abstract This article presents the design and radiation characteristics of a dualβmode corrugated matched feed horn. This type of feed eliminates the unwanted high crossβpolarization of an offset parabolic reflector antenna and improves the overall performance of the antenna subβsystem. In a cyl