𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Design, fabrication and thermal characterization of a magnetocaloric microcooler

✍ Scribed by S. Kim; S. Ghirlanda; C. Adams; B. Bethala; S. N. Sambandam; S. Bhansali

Publisher
John Wiley and Sons
Year
2007
Tongue
English
Weight
321 KB
Volume
31
Category
Article
ISSN
0363-907X

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Design, fabrication, and characterizatio
Design, fabrication, and characterization of patch antenna using superconducting thin film
✍ Katsufumi Ehata; Masanobu Kusunoki; Shigetoshi Ohshima πŸ“‚ Article πŸ“… 1999 πŸ› John Wiley and Sons 🌐 English βš– 447 KB πŸ‘ 1 views

The surface resistance of superconductors is smaller than that of normal conductors by several orders of magnitude. Hence, a superconducting microwave device has lower loss and higher performance than a normal conducting one. Since the mobile communication systems have become popular and cryocoolers

Fabrication and characterization of a si
Fabrication and characterization of a silicon microvalve
✍ Γ…sa Emmer; MΓ₯rten Jansson; Johan Roeraade; Ulf Lindberg; Bertil HΓΆk πŸ“‚ Article πŸ“… 1992 πŸ› John Wiley and Sons 🌐 English βš– 225 KB

## Abstract The fabrication of a unidirectional micro‐valve in silicon is reported. Pressure/flow characteristics between 0–1 bar for water were measured. Practically no leakage was observed (less than 1 nL min^βˆ’1^) when the valve was pressurized in the backward direction. A nonlinear pressure‐flow

Design, fabrication and testing of a hel
Design, fabrication and testing of a helium cooled module
✍ C.B Baxi; J Smith; D Youchison πŸ“‚ Article πŸ“… 1995 πŸ› Elsevier Science 🌐 English βš– 693 KB

Helium cooling has been shown to be very attractive from safety considerations as a coolant for ITER. However, there is a concern that use of helium will result in large manifolds and large pumping power. The purpose of this task was to design, fabricate and test a helium cooled divertor module for