Abstract
It is well known that cutting knifes in the wood industry often suffer from corrosion. Investigations showed that the corrosiveness of different wood types is responsible for a major part of the damage, and that different woods have a different corrosive impact. It is revealed that tannin, a water‐soluble acid, which can be found in all woods in different concentrations, is the most aggressive acid contained in the wood, and so it is responsible for the main part of the corrosive attack. In view of the above, the ability of different cold‐work steels to resist corrosion caused by tannic acid has been investigated. Often corrosion is measured by the mass loss of the sample divided by the surface of the sample under certain conditions during a fixed period of time. One problem with this method is that there is also a weight gain caused by oxidation or by other side reactions at the samples surface. So in some cases the weight of the sample even increases during the testing time, which makes the quantification of the corrosion impossible with this method. Due to the reasons already mentioned, another method was used to quantify the test results. This method is based on inductive coupled plasma–optical emission spectral analyses (ICP‐OES), where the released Fe is quantified. The results of the corrosion resistant tests get correlated to the microstructure and the elemental composition of the analysed cold‐work steels. The present investigations improve the understanding of important material parameters to enhance the corrosion resistance against tannin. It is revealed that the higher the primary carbide concentration is the more Cr or other passivating elements are necessary in the matrix to show a good protection against corrosion by tannin. Three materials with different elemental compositions have been investigated, and for one of those materials the influence of different heat treatments was also analysed. The investigations could show that annealing parameters and freeze‐cycle processing (FCP) have less impact on the corrosion resistance to tannin than elemental composition and austenitising temperature.