๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

An experimental study of the V-notch fatigue test

โœ Scribed by D.S. Dugdale

Publisher
Elsevier Science
Year
1959
Tongue
English
Weight
511 KB
Volume
7
Category
Article
ISSN
0022-5096

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Study of fatigue crack initiation in the
Study of fatigue crack initiation in the vicinity of notches
โœ K. Saanouni; C. Bathias ๐Ÿ“‚ Article ๐Ÿ“… 1982 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 788 KB

Using the crack initiation measurements for notched specimens with various geometry (CT and axisymetric notched specimens) and different notch radii, we will try to determine the number of cycles to initiate a fatigue crack in the vicinity of stress concentration. ## NOMENCLATURE nominal stress a

AN EXPERIMENTAL STUDY ON THE NOISE CHARA
AN EXPERIMENTAL STUDY ON THE NOISE CHARACTERISTICS OF NOTCHED CIRCULAR-SLOT JETS
โœ S.B. VERMA; E. RATHAKRISHNAN ๐Ÿ“‚ Article ๐Ÿ“… 1999 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 203 KB

Jet characteristics are most receptive to changes in initial conditions, which play a dominant role in the development of both low [1}3] and high-speed [4] jets. From the literature it is seen that jets from non-circular geometries [1}3, 5, 6] result in enhanced mixing, a characteristic making them

An experimental study of the influence o
An experimental study of the influence of inclusions on the fatigue properties of steel
โœ Gunnar Hรคrkegรฅrd ๐Ÿ“‚ Article ๐Ÿ“… 1974 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 1011 KB

Thickness-direction specimens have been produced from a number of steel forgings differing mainly with respect to inclusion characteristics. After heat treatment specimens are fatigued and fracture surfaces are examined by means of scanning-electron microscopy in order to determine the site of fatig

An experimental study of fatigue crack i
An experimental study of fatigue crack initiation and growth from coldworked holes
โœ Nopporn Chandawanich; William N. Sharpe Jr. ๐Ÿ“‚ Article ๐Ÿ“… 1979 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 714 KB

The behavior of specimens with holes that were coldworked by radial expansion was studied. The initiation and growth of fatigue cracks was observed for a remote cyclic loading that generated stresses at the hole edge slightly above the yield stress. Coldworking affected the growth rate, not the init