✦ LIBER ✦

Advanced sealing system for high pressure valves

Publisher: Elsevier Science
Year: 1995
Tongue: English
Weight: 101 KB
Volume: 1995
Category: Article
ISSN: 1350-4789
DOI: 10.1016/1350-4789(95)90096-9

No coin nor oath required. For personal study only.

✦ Synopsis

Dynamic sealing

power consumption is greatly reduced through the optimization of the friction face width and material selection.

Specific attention to detail, llke surface finish underneath the O-ring and design of the antlrotation system, guarantees an increased service life. Lack of space around the friction faces is often the reason for the rapid failure of the seal through overheating or erosion. A wide circular cavity machined in the seal cover increases the volume of fluid around the seal faces. The seal service life increases accordingly.

📜 SIMILAR VOLUMES

Seal-off valve for vacuum systems

📂 Article 📅 1954 🏛 Elsevier Science 🌐 English ⚖ 67 KB

A seal-off valve possessing several advantages for high-vacuum work has been devised by R. J. Richards of the National Bureau of Standards. The valve is designed so that its handle and stem can be readily removed and used with any number of seal-off seats, leaving only the closed valve seat on the e

Seal-off valve for vacuum systems

✍ Anon 📂 Article 📅 1954 🏛 Elsevier Science 🌐 English ⚖ 91 KB

Insulating seal for high-pressure equipm

Insulating seal for high-pressure equipment

📂 Article 📅 1955 🏛 Elsevier Science 🌐 English ⚖ 184 KB

Valve stem packing for high temperatures

Valve stem packing for high temperatures and pressures

📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 451 KB

## Dynamic sealing to 60% versus conventional wide unbalanced faces; the patent-pending graphite holder provides uniform pressure for better face squareness, tighter tolerances and greater sealing reliability. This eliminates the usual metal holder whose interference fit can cause uneven, distorti

High vacuum, high pressure valve for use

High vacuum, high pressure valve for use in a cryostat

✍ H.H. Chen; R.A. Aziz; C.C. Lim 📂 Article 📅 1976 🏛 Elsevier Science 🌐 English ⚖ 197 KB

Dry gas seals for low and high pressure

✍ A. Gesche; J. Nosowicza; D. Zeus 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 457 KB

The following article reviews test results accumulated on gas lubricated seals for compressors. The influence of various combinations of materials on the operating behaviour of the seals is also analyzed. Figure 1. Single gas seal with low consumption back up seals, type DGS3/150-E1-R