𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Insulating seal for high-pressure equipment

Publisher
Elsevier Science
Year
1955
Tongue
English
Weight
184 KB
Volume
260
Category
Article
ISSN
0016-0032

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Advanced sealing system for high pressur
Advanced sealing system for high pressure valves
πŸ“‚ Article πŸ“… 1995 πŸ› Elsevier Science 🌐 English βš– 101 KB

## Dynamic sealing power consumption is greatly reduced through the optimization of the friction face width and material selection. Specific attention to detail, llke surface finish underneath the O-ring and design of the antlrotation system, guarantees an increased service life. Lack of space ar

Dry gas seals for low and high pressure
Dry gas seals for low and high pressure
✍ A. Gesche; J. Nosowicza; D. Zeus πŸ“‚ Article πŸ“… 1994 πŸ› Elsevier Science 🌐 English βš– 457 KB

The following article reviews test results accumulated on gas lubricated seals for compressors. The influence of various combinations of materials on the operating behaviour of the seals is also analyzed. Figure 1. Single gas seal with low consumption back up seals, type DGS3/150-E1-R

Non-contacting face seal for extended eq
Non-contacting face seal for extended equipment life
πŸ“‚ Article πŸ“… 1995 πŸ› Elsevier Science 🌐 English βš– 233 KB

The standard O-rings are fluoroelastomer; however many other materials are available to meet varying cost and performance requirements. The standard ProTech is a single-port expulsion design with an external flange or a flush-mount design. In addition, however it is available in a multi-port expuls

Metal–insulator transition under high pr
Metal–insulator transition under high pressure in
✍ Hiroyuki Hidaka; Ikuma Ando; Hisashi Kotegawa; Tatsuo C. Kobayashi; Hisatomo Har πŸ“‚ Article πŸ“… 2005 πŸ› Elsevier Science 🌐 English βš– 171 KB

We have studied the electrical resistivity in a skutterudite compound PrFe 4 P 12 under high pressure. An antiferroquadrupolar ordering temperature T Q decreases monotonously with increasing pressure up to 2.4 GPa. Above 2.4 GPa, the metal-insulator (M-I) transition appears. By applying magnetic fie