✦ LIBER ✦

A novel planar three-way triband power divider

✍ Scribed by Xin-Huai Wang; Xiaoqun Chen; Xiao-Wei Shi; Feng Wei; Yanfu Bai

Publisher: John Wiley and Sons
Year: 2010
Tongue: English
Weight: 143 KB
Volume: 52
Category: Article
ISSN: 0895-2477
DOI: 10.1002/mop.24858

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

A novel planar three‐way triple‐band power divider is proposed in this article. The circuit is composed of three sections of three transmission lines and planar isolation resistors, which can provide high isolation and good amplitude balance simultaneously at three arbitrary frequencies. The structure of the power divider and the formulas used to determine the design parameters has been given. To verify the validity, a proposed power divider was fabricated and measured at 900, 1800, and 2400 MHz. Both theoretical and simulated results are presented, which are in good agreement with the measured results. © 2009 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52: 182–184, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.24858

📜 SIMILAR VOLUMES

A new wideband three-way power divider

✍ Guan-Yu Chen; Jwo-Shiun Sun 📂 Article 📅 2007 🏛 John Wiley and Sons 🌐 English ⚖ 247 KB

## Abstract A new three‐way power divider that provides equal power split over a wide bandwidth implemented on a single‐layer printed circuit board (PCB) is presented. It can be easily extended to an arbitrary number of output ports. The proposed power divider exhibits fairly good performance valid

A compact three-way dual-frequency power

A compact three-way dual-frequency power divider

✍ Xinhuai Wang; Dongzhou Chen; Xiaowei Shi; Feng Wei; Xiaoqun Chen 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 193 KB

## Abstract In this article, a compact three‐way dual‐frequency power divider is proposed. The circuit is composed of two sections of three transmission lines and four RLC networks. The RLC networks using planar lumped inductors, capacitors, and resistors can provide enough isolation and good ampli

Planar three-way power divider using sho

Planar three-way power divider using short terminated stubs in the center of isolation bridges

✍ Yukio Ikeda; Fumio Takeda; Kazuya Tuda; Osami Ishida 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 199 KB

Planar ultra wideband inphase power divi

Planar ultra wideband inphase power divider

✍ A. M. Abbosh 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 189 KB

## Abstract A planar inphase power divider, which has ultra wideband performance, is presented. The proposed device utilizes a T‐microstrip junction combined with an electromagnetic coupling between a slotted ground plane and an elliptical patch at the centre of the T‐junction. A resistor is also u

A compact 1-to-8 planar spatial power di

A compact 1-to-8 planar spatial power divider/combiner

✍ Jun-Mei Yan; Qing-Xin Chu 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 332 KB

## Abstract A compact 1‐to‐8 planar spatial power divider/combiner is proposed. It employs two dielectric substrates with a common ground plane. Two transitions are cascaded to divide power equally. The first transition is from a parallel stripline to two microstrip lines and the second transition

A two-way power divider using coupled li

A two-way power divider using coupled lines and capacitances

✍ Yunseung Chang; Toshikazu Sekine; Takashi Nakamura; Senji Yokokawa 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 625 KB