## Abstract A Q‐band low‐noise amplifier (LNA) suitable for low‐voltage operation is presented in this paper.The amplifier uses a low‐voltage cascode structure in the first stage of the amplifier and was fabricated using a 0.13‐μm RF CMOS process with eight layers of copper metallization. Low‐volta
A low voltage balanced Clapp VCO in 0.13 micromolar CMOS technology
✍ Scribed by Sheng-Lyang Jang; Cheng-Chen Liu; Yi-Jhe Song; M.-H. Juang
- Publisher
- John Wiley and Sons
- Year
- 2010
- Tongue
- English
- Weight
- 294 KB
- Volume
- 52
- Category
- Article
- ISSN
- 0895-2477
No coin nor oath required. For personal study only.
✦ Synopsis
A balanced voltage-controlled oscillator (VCO) is designed and implemented in a 0.13 lm CMOS 1P8M process. The designed VCO circuit topology is an all nMOS LC-tank Clapp VCO using a series-tuned resonator. At the supply voltage of 0.5 V, the output phase noise of the VCO is À108.69 dBc/Hz at 1 MHz offset frequency from the carrier frequency of 17.72 GHz, and the figure of merit is À186.84 dBc/Hz. The core power consumption is 4.2 mW. Tuning range is about 3.
📜 SIMILAR VOLUMES
## Abstract A low‐power 63‐GHz (V‐band) direct injection‐locked frequency‐divider (ILFD) using standard 0.13‐μm CMOS technology is reported. To reduce power consumption and enhance locking range, a PMOS switch directly coupled to the LC tank (output) of the ILFD is used to replace the traditional t
## Abstract The design of a 10‐GHz voltage‐controlled oscillator (VCO) for synchronous optical network (SONET) applications is presented in this paper. The circuit is fabricated in 0.18‐μm RF CMOS process and it has a phase noise of −95 dBc/Hz at 1‐MHz offset and a very low power consumption of 2.5
## Abstract A low phase noise tuned‐input tuned‐output (TITO) voltage‐controlled oscillator (VCO) using PMOS transistors is presented in this article.The TITO‐VCO, implemented using a 0.18 μm RF CMOS process, resulted in a phase noise performance of −118 dBc/Hz at 1 MHz offset from the center frequ