๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

222. Chemical vapor deposition of carbon matrices

โœ Scribed by T. Jachlewski; R.J. Diefendorf

Publisher
Elsevier Science
Year
1982
Tongue
English
Weight
143 KB
Volume
20
Category
Article
ISSN
0008-6223

No coin nor oath required. For personal study only.

โœฆ Synopsis

The work-of-fracture (ywOF) of carbon-carbon composites was measured for composites with 3-D woven fiber preforms, carbon felts, and chopped fibers. Maximum values were observed for the 3-D preforms and minimum values for the carbon felts. The values are also compared with similar data for graphites and glassy carbon.

๐Ÿ“œ SIMILAR VOLUMES

The chemical vapor deposition of carbon
The chemical vapor deposition of carbon on carbon fibers
โœ H.O. Pierson; M.L. Lieberman ๐Ÿ“‚ Article ๐Ÿ“… 1975 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 775 KB

The relations between chemical vapor deposition (CVD) parameters and the resultant pyrolytic carbon microstructures have been examined for matrix deposition in fibrous carbon substrates. The parameters considered are temperature (1200-145O"C), pressure (20-630 Torr), C/H ratio (l/4-1/14), total flow

Micromechanics of carbon fibers โ€” chemic
Micromechanics of carbon fibers โ€” chemical vapor deposited carbon composites
โœ B.L. Butler ๐Ÿ“‚ Article ๐Ÿ“… 1972 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 136 KB

AASTRACTS 331 ment. The electron microscope (both in the scanning and transmission modes) was used to examine the topography of both wet (60% HNOs, 118ยฐC) and dry oxidized (air, 700ยฐC) fibers as well as fracture surfaces of composites made with treated and untreated fibers. The flexural strength of

Failure behavior of carbon/carbon compos
Failure behavior of carbon/carbon composites prepared by chemical vapor deposition
โœ K.Y. Sohn; Oh Seh-Min; Lee Jai-Young ๐Ÿ“‚ Article ๐Ÿ“… 1988 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 878 KB

## Abstrad-Tensile tests have been performed on carbon/carbon composites made from carbon cloths and a pyrolytic carbon matrix and their failure surfaces were examined by scanning electron microscopy. The load-extension curves are characterized by three distinct regions: the applied load needed to