✦ LIBER ✦

Wear and Tool Life of CBN Cutting Tools

✍ Scribed by A.G. Mamalis; J. Kundrák; M. Horváth

Publisher: Springer
Year: 2002
Tongue: English
Weight: 111 KB
Volume: 20
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s001700200180

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

An investigation of heat partition and t

An investigation of heat partition and tool wear in hard turning of H13 tool steel with CBN cutting tools

✍ Mohammad Usman Ghani; Nuri A. Abukhshim; M. A. Sheikh 📂 Article 📅 2008 🏛 Springer 🌐 English ⚖ 843 KB

Optimum cutting tool geometry when inter

Optimum cutting tool geometry when interrupted cutting carburized steel by CBN tool

✍ K. Shintani; M. Ueki; Y. Fujimura 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 759 KB

Comparison of tool life between ceramic

Comparison of tool life between ceramic and cubic boron nitride (CBN) cutting tools when machining hardened steels

✍ Y. Sahin 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 727 KB

This paper describes a comparison of tool life between ceramics and cubic boron nitride (CBN) cutting tools when machining hardened bearing steels using the Taguchi method. An orthogonal design, signal-to-noise ratio (S/N) and analysis of variance (ANOVA) were employed to determine the effective cu

High speed milling of steel and tool lif

High speed milling of steel and tool life - tool life of CBN ball end mill

✍ Tadahiro Ikeda; Toshitaka Matsuoka 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 162 KB

The effects of cutting speed on tool wea

The effects of cutting speed on tool wear and tool life when machining Inconel 718 with ceramic tools

✍ A. Altin; M. Nalbant; A. Taskesen 📂 Article 📅 2007 🏛 Elsevier Science ⚖ 667 KB

Modelling of CBN tool crater wear in fin

Modelling of CBN tool crater wear in finish hard turning

✍ Yong Huang; Steven Y. Liang 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 977 KB