✦ LIBER ✦

The effects of cutting speed on tool wear and tool life when machining Inconel 718 with ceramic tools

✍ Scribed by A. Altin; M. Nalbant; A. Taskesen

Publisher: Elsevier Science
Year: 2007
Weight: 667 KB
Volume: 28
Category: Article
ISSN: 0261-3069
DOI: 10.1016/j.matdes.2006.09.004

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The effect of coating material and geome

The effect of coating material and geometry of cutting tool and cutting speed on machinability properties of Inconel 718 super alloys

✍ Muammer Nalbant; Abdullah Altın; Hasan Gökkaya 📂 Article 📅 2007 🏛 Elsevier Science ⚖ 385 KB

Surface abuse when machining cast iron (

Surface abuse when machining cast iron (G-17) and nickel-base superalloy (Inconel 718) with ceramic tools

✍ E.O. Ezugwu; S.H. Tang 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 699 KB

Comparison of tool life between ceramic

Comparison of tool life between ceramic and cubic boron nitride (CBN) cutting tools when machining hardened steels

✍ Y. Sahin 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 727 KB

This paper describes a comparison of tool life between ceramics and cubic boron nitride (CBN) cutting tools when machining hardened bearing steels using the Taguchi method. An orthogonal design, signal-to-noise ratio (S/N) and analysis of variance (ANOVA) were employed to determine the effective cu

The effect of tool geometry and cutting

The effect of tool geometry and cutting speed on main cutting force and tool tip temperature

✍ Haci Saglam; Suleyman Yaldiz; Faruk Unsacar 📂 Article 📅 2007 🏛 Elsevier Science ⚖ 262 KB

Effect of different heat treatments on t

Effect of different heat treatments on the wear of high speed steel cutting tools

✍ E.D. Doyle 📂 Article 📅 1974 🏛 Elsevier Science 🌐 English ⚖ 838 KB

Layer formation on the rake face of a cu

Layer formation on the rake face of a cutting tool and its effect on tool life

✍ K. Ohgo; K. Nakajima; T. Awano 📂 Article 📅 1976 🏛 Elsevier Science 🌐 English ⚖ 473 KB