✦ LIBER ✦

Unavoidable geometric errors in the side walls of end-milled parts —Flat surface—

✍ Scribed by Kang Kim

Publisher: Springer-Verlag
Year: 2007
Tongue: English
Weight: 567 KB
Volume: 21
Category: Article
ISSN: 1738-494X
DOI: 10.1007/bf03161711

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Unavoidable geometric errors in the side

Unavoidable geometric errors in the side walls of end-milled parts-cylindrical surface-

✍ Kun Sang Lee; Kang Kim 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 562 KB

Analysis of unavoidable geometric errors

Analysis of unavoidable geometric errors in the side wall of end-milled parts for corner surface

✍ Kun Sang Lee; Kang Kim 📂 Article 📅 2009 🏛 Springer-Verlag 🌐 English ⚖ 677 KB

Dynamic modeling for the prediction of s

Dynamic modeling for the prediction of surface errors in the milling of thin-walled sections

✍ M.A. Elbestawi; R. Sagherian 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 661 KB

In this paper, computer simulation techniques capable of predicting, off-line, the resulting geometric errors in the finish end-milling of thin-walled sections are presented. The effects of workpiece and cutter dynamic deflections on the chip load are included in the model. The workpiece dynamics ar

The prediction of dimensional error for

The prediction of dimensional error for sculptured surface productions using the ball-end milling process. Part 2: Surface generation model and experimental verification

✍ Ee Meng Lim; Chia-Hsiang Menq 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 757 KB

Study on Accuracy in Micro End Mill Oper

Study on Accuracy in Micro End Mill Operations. (1st Report, Deflection of End Mill and Accuracy of Machined Surface: T. Shibasaka, T. Toshima, M. Fujita, Transactions of the Japan Society of Mechanical Engineers, Part C, 56(526), pp. 1597–1601. (Jun 1990)

📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 154 KB