✦ LIBER ✦

Analysis of unavoidable geometric errors in the side wall of end-milled parts for corner surface

✍ Scribed by Kun Sang Lee; Kang Kim

Publisher: Springer-Verlag
Year: 2009
Tongue: English
Weight: 677 KB
Volume: 23
Category: Article
ISSN: 1738-494X
DOI: 10.1007/s12206-008-1129-7

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Unavoidable geometric errors in the side

Unavoidable geometric errors in the side walls of end-milled parts —Flat surface—

✍ Kang Kim 📂 Article 📅 2007 🏛 Springer-Verlag 🌐 English ⚖ 567 KB

Unavoidable geometric errors in the side

Unavoidable geometric errors in the side walls of end-milled parts-cylindrical surface-

✍ Kun Sang Lee; Kang Kim 📂 Article 📅 2008 🏛 Springer-Verlag 🌐 English ⚖ 562 KB

Dynamic modeling for the prediction of s

Dynamic modeling for the prediction of surface errors in the milling of thin-walled sections

✍ M.A. Elbestawi; R. Sagherian 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 661 KB

In this paper, computer simulation techniques capable of predicting, off-line, the resulting geometric errors in the finish end-milling of thin-walled sections are presented. The effects of workpiece and cutter dynamic deflections on the chip load are included in the model. The workpiece dynamics ar

The prediction of dimensional error for

The prediction of dimensional error for sculptured surface productions using the ball-end milling process. Part 2: Surface generation model and experimental verification

✍ Ee Meng Lim; Chia-Hsiang Menq 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 757 KB