✦ LIBER ✦

Ti6A14V laser alloying process control by using a self-organizing fuzzy controller

✍ Scribed by Hung-Yi Chen; Shiuh-Jer Huang

Book ID: 108145818
Publisher: Elsevier Science
Year: 2004
Tongue: English
Weight: 344 KB
Volume: 44
Category: Article
ISSN: 0890-6955
DOI: 10.1016/j.ijmachtools.2004.05.002

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Fuzzy Logic Control for the Ti6A14V Lase

Fuzzy Logic Control for the Ti6A14V Laser Alloying Process

✍ S.W. Shieh; S.J. Huang; L. Li 📂 Article 📅 2001 🏛 Springer 🌐 English ⚖ 150 KB

Ti6Al4V laser alloying process monitorin

Ti6Al4V laser alloying process monitoring by using adaptive neural network controller

✍ Hung-Yi Chen; Shiuh-Jer Huang 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 580 KB

Since the surface alloying process has multi-input and multi-output, non-linear coupling and time varying dynamic characteristics, it is very difficult to establish an accurate process model for designing model-based controller. Hence an adaptive neural network controller is developed in this paper

Adaptive fuzzy sliding-mode control for

Adaptive fuzzy sliding-mode control for the Ti6Al4V laser alloying process

✍ Hung-Yi Chen; Shiuh-Jer Huang 📂 Article 📅 2004 🏛 Springer 🌐 English ⚖ 324 KB

Control of a fed-batch fermentation proc

Control of a fed-batch fermentation process using a self-organizing fuzzy controller : Myeong Seok Park, Yong Keun Chang, pp 255–259

📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 126 KB

Self-organizing fuzzy controller for the

Self-organizing fuzzy controller for the molten steel level control of a twin-roll strip casting process

✍ Hung-Yi Chen; Shiuh-Jer Huang 📂 Article 📅 2009 🏛 Springer US 🌐 English ⚖ 425 KB

Process optimization of Ti–Nb alloy coat

Process optimization of Ti–Nb alloy coatings on a Ti–6Al–4V plate using a fiber laser and blended elemental powders

✍ Vahid Fallah; Stephen F. Corbin; Amir Khajepour 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 762 KB

A fiber laser was used to modify the surface composition of a Ti-6Al-4V plate through deposition of the blown powder mixture of Ti-45 wt.%Nb. Scanning electron microscopy and energy dispersive spectroscopy (EDS) were employed to examine the clad sections microstructure and chemical composition. The