𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Fuzzy Logic Control for the Ti6A14V Laser Alloying Process

✍ Scribed by S.W. Shieh; S.J. Huang; L. Li

Publisher
Springer
Year
2001
Tongue
English
Weight
150 KB
Volume
18
Category
Article
ISSN
0268-3768

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Ti6Al4V laser alloying process monitorin
Ti6Al4V laser alloying process monitoring by using adaptive neural network controller
✍ Hung-Yi Chen; Shiuh-Jer Huang πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 580 KB

Since the surface alloying process has multi-input and multi-output, non-linear coupling and time varying dynamic characteristics, it is very difficult to establish an accurate process model for designing model-based controller. Hence an adaptive neural network controller is developed in this paper

Process optimization of Ti–Nb alloy coat
Process optimization of Ti–Nb alloy coatings on a Ti–6Al–4V plate using a fiber laser and blended elemental powders
✍ Vahid Fallah; Stephen F. Corbin; Amir Khajepour πŸ“‚ Article πŸ“… 2010 πŸ› Elsevier Science 🌐 English βš– 762 KB

A fiber laser was used to modify the surface composition of a Ti-6Al-4V plate through deposition of the blown powder mixture of Ti-45 wt.%Nb. Scanning electron microscopy and energy dispersive spectroscopy (EDS) were employed to examine the clad sections microstructure and chemical composition. The

Surface engineering techniques used for
Surface engineering techniques used for improving the mechanical and tribological properties of the Ti6A14V alloy
✍ H. Garbacz; P. WieciΕ„ski; M. Ossowski; M.G. Ortore; T. WierzchoΕ„; K.J. KurzydΕ‚ow πŸ“‚ Article πŸ“… 2008 πŸ› Elsevier Science 🌐 English βš– 905 KB

The microstructure, mechanical and tribological properties of composite intermetallic layers of the Ti-Al system were investigated. The layers on the two-phase (Ξ± + Ξ²) Ti6Al4V titanium alloy were obtained using the hybrid method, which consist of two stages. First, the titanium alloy was covered wit