Thermally recoverable crosslinked polyethylene
β Scribed by Suresh Kumar; M. V. Pandya
- Publisher
- John Wiley and Sons
- Year
- 1997
- Tongue
- English
- Weight
- 199 KB
- Volume
- 64
- Category
- Article
- ISSN
- 0021-8995
No coin nor oath required. For personal study only.
β¦ Synopsis
The thermal recovery of the stored stress in crosslinked polyethylene has been commercially exploited in the preparation of heat shrinkable materials. The study on thermally recoverable crosslinked polyethylene compositions is reported in this paper. Thermally recoverable compositions were prepared by crosslinking of four grades of polyethylenes in air using g-rays from a Co-60 source. The effect of the irradiation dose on the gel fraction and radiation dose to gelation is studied. The effect of the melt index (MI) and the density of the polyethylene on the gel fraction, radiation dose to gelation, and recovery percentage of the stored stress is also studied. It is observed that the gel fraction is higher in case of the lower MI material and that rate of recovery is higher at higher temperatures. The rate of recovery of the stored stress is higher in case of the 100 kGy irradiated sample.
π SIMILAR VOLUMES
Vinyl trimethoxysilane grafting reactions of low-density polyethylene (LDPE) were performed in an extruder, followed by crosslinking with boiled water. The thermal properties of both silane-grafted and silane-grafted water-crosslinked LDPE were investigated using differential scanning calorimetry (D
An experimental study on the thermal expansion of a collection of crosslinked low-density polyethylene (LDPE) foams with closed-cell structure is presented. The thermal characterization of these materials, the relationships between the linear thermal expansion coefficient and the structure of the fo
Thin strips of crosslinked linear high-density polyethylene were melted and then crystallized in contact by cooling to room temperature. The work required to peel the strips apart by pulling one strip away from the other at 90Π was found to be remarkably high, 5 to 30 kJ/m 2 , and in some cases the